EN
NOTE When the motion sensor on the nightlight is turned on, it needs approximately 2 minutes to warm up before giving a response.
ACTIVATING THE CLOCK BACKLIGHT USING THE CONTROL BUTTON
You can control the backlight of the clock through the nightlight. You can set the backlight to the following options:
1.Control On - The clock backlight is controlled by the activation of the nightlight.
z Slide the Clock Control switch to On.
2.Control Off - The nightlight does not control the clock backlight.
z Slide the Clock Control switch to Off.
NOTE See the Clock Backlight section, which shows you how to set the nightlight sensors to be activated at times specified by you.
THE CODE SWITCH
The Code switch on the nightlight must be set to the same setting as the Code setting on the clock. The Code allows the nightlight to recognize the clock’s settings.
THE CHANNEL SWITCH
Up to 2 nightlights can be linked to 1 wall clock. (An additional nightlight can be purchased separately.) By setting 1 nightlight to Channel 1 and the other to Channel 2, the clock display can tell you which sensor has been activated by flashing “ch. 1” or “ch.2” on the display.
+ LIGHT - ROTARY KNOB
The light sensor’s level of sensitivity can be adjusted. Turn the Light rotary knob towards + to make it more sensitive to light or - to make it less sensitive to light.
RESET BUTTON
Insert a thin blunt instrument into the hole below Reset to return to the default settings.
The default settings are:
Clock Time: | 12.00 PM |
Date: | 1st January 2004 |
Time Offset: | +0 |
Alarm Time: | 6.00 AM |
Daily Alarm: | Disabled |
Motion Alarm Start Time: | 12.00 AM |
Motion Alarm Stop Time: | 6.00 AM |
Motion Alarm: | Disabled |
UK Display Setting: | 12hr, DD / MM,°C |
EU Display Setting: | 24hr, DD / MM,°C |
8
