METEO
Weather Forecast Watch
Model: RA121
USER MANUAL
EN
INTRODUCTION
Thank you for selecting the Oregon Scientifi c™ METEO Weather Forecast Watch (RA121). Equipped with real- time clock, stopwatch, alarm, backlight and keypad lock functions, this watch can also be used for providing daily weather forecast.
IMPORTANT
•The measurement functions built into the RA121 are not meant to substitute professional measurement
or industrial precision devices. Values produced by this device should be considered as reasonable representations only.
•Oregon Scientifi c™ assumes no responsibility for any loss, or any claims by third parties that may arise through the use of this device.
CONTROL BUTTONS
1 |
|
|
|
|
|
| 3 |
|
| ||||||
|
|
|
|
|
|
| 4 |
|
|
|
|
|
|
| |
2 |
|
|
|
|
|
| 5 |
|
|
|
|
|
| ||
|
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1.MODE : Switch to another display; quick exit during any setting mode
2.SET: Enter setting mode; confi rm setting value
3.ST / SP / + : Increase value of the setting; start / stop stopwatch
4.
/ 
: Activate backlight; lock keypad
5.RST /
LCD
1
2
3 
5
6
4
7
8
1.Displays weather forecast
2.
: Indicates keypad is locked
3.
: Indicates beep tone is turned Off
4.Displays clock, calendar, stop watch, alarm time or mode banners
5.
: Indicates alarm is On
6.
: Indicates stopwatch is displayed or running
7.
: 12 hour clock
8.
or 
: Indicates battery power is low
GETTING STARTED
TURN ON DEVICE
Press any key for 2 seconds to activate the LCD display.
BATTERY REPLACEMENT
The RA121 uses a CR2032 3V battery, which has already been installed. See below for battery warnings.
INDICATION DESCRIPTION
The battery is low.
The battery is too low to operate.
The weather icon is cleared.
NOTE While the low battery icon is displayed, weather forecast, alarm beeping and backlight are disabled. It will return to normal once battery has been replaced.
NOTE If you need to replace the battery, we highly recommend you to contact the retailer or our customer service department.
To replace the battery:
1.Use a small Phillips screwdriver to remove battery compartment lid. Once opened, please keep the screws in a safe place to avoid losing them.
2.Remove the old battery and insert the new one, matching the polarities.
3.Replace the lid by screwing it back into place using a Phillips screwdriver.
OPERATING MODES
Press MODE to switch between:
•Time Mode
•Date Mode
•Chrono (Stopwatch) Mode
•Alarm Mode
TIME MODE
This mode is used for viewing the current time and weather forecast, and for setting the time and date.
TO SET TIME AND DATE
1.Press MODE to navigate to Time Mode.
2.Press and hold SET to enter settings.
3.Press ST/SP/+ or RST/- to change values of the setting. Press and hold ST/SP/+ or RST/- to rapidly change values.
4.Press SET to confi rm and move to the next setting. Repeat steps
5.Press MODE anytime to confi rm and exit settings.
DATE MODE
This mode is used for viewing the current date and weather forecast. Press MODE to navigate to Date Mode.
STOPWATCH MODE (CHRONO)
TO START / STOP STOPWATCH
1.Press MODE to navigate to Chrono Mode.
2.Press ST/SP/+ to start / stop stopwatch.
TO RESET STOPWATCH
Press RST/- to reset stopwatch.
NOTE Stopwatch can be reset to 00:00:00 only if it has been stopped or paused.
ALARM MODE
TO SET ALARM
1.Press MODE to navigate to Alarm Mode.
2.Press and hold SET to enter settings.
3.Press ST/SP/+ or RST/- to change values of the setting. Press and hold ST/SP/+ or RST/- to rapidly change values.
4.Press SET to confi rm and move to the next setting. Repeat steps
5.Press MODE anytime to confi rm and exit settings.
TO ACTIVATE / DEACTIVATE ALARM
1.Press MODE to navigate to Alarm Mode.
2.Press ST/SP/+ or RST/- to activate / deactivate alarm.
indicates that the alarm has been activated.
3.Press MODE to confi rm and exit.
TO SILENCE ALARM
When the alarm clock is activated, it will sound at the set time every day. Press any button to stop the alarm for that day.
NOTE The alarm clock is still active and will set off again the following day.
BACKLIGHT AND KEYPAD LOCK
To activate backlight:
Press 
/ 
to turn backlight On for 5 seconds.
NOTE The backlight function will not operate if “ | ” or | |
“ | ” is displayed. |
|
To toggle keypad lock On or Off:
Press and hold 
/ 
for 2 seconds. 
indicates keypad is locked.
WEATHER FORECAST
This watch forecasts the next 12 to 24 hours of weather.
Sunny | Partially | Cloudy | Rainy | |
Cloudy | ||||
|
|
|
USE IN THE WATER
The RA121 is
| RAIN | SHOWERING | LIGHT | SHALLOW | SNORKELING/ | |
| SPLASHES | (WARM / | SWIMMING / | DIVING / | DEEP | |
| ETC | COOL | SHALLOW | SURFING / | WATER | |
|
| WATER | WATER | WATER | DIVING | |
|
| ONLY) |
| SPORTS |
| |
30M / | OK | NO | NO | NO | NO | |
98 FEET | ||||||
|
|
|
|
|
NOTE Set the watch before exposing it to excessive water. Pressing the keys while in the water or during heavy rainstorms may cause water to enter the watch.
SPECIFICATIONS
Real time clock | 12/24 format with hour / minute / | |
second | ||
| ||
Stopwatch | 00:00:00 to 99:59:59 (hr:min:sec) | |
Power | 1 x CR2032 3V battery | |
Operating temperature | 0°C to 40°C (32°F to 104°F) | |
Storage temperature |
PRECAUTIONS
To ensure you use your product correctly and safely, read these warnings and the entire user manual before using the product:
•Use a soft, slightly moistened cloth. Do not use abrasive or corrosive cleaning agents, as these may cause damage. Use lukewarm water and mild soap to clean the watch. Never use the products in hot water or store them when wet.
•Do not subject the product to excessive force, shock, dust, temperature changes, or humidity. Never expose the product to direct sunlight for extended periods. Such treatment may result in malfunction.
•Do not tamper with the internal components. Doing so will terminate the product warranty and may cause damage. The main unit contains no
•Do not scratch hard objects against the LCD display as this may cause damage.
•Take precautions when handling all battery types.
•Remove the batteries whenever you are planning to store the product for a long period of time.
•When replacing batteries, use new batteries as specifi ed in this user manual.
•The product is a precision instrument. Never attempt to take this device apart. Contact the retailer or our customer service department if the product requires servicing.
•Do not touch the exposed electronic circuitry, as there is a danger of electric shock.
•Check all major functions if the device has not been used for a long time. Maintain regular internal testing and cleaning of your device. Have your watch serviced by an approved service center annually.
•When disposing of this product, ensure it is collected separately for special treatment and not as normal household waste.
•Due to printing limitations, the displays shown in this manual may differ from the actual display.
•The contents of this manual may not be reproduced without the permission of the manufacturer.
NOTE The technical specifi cations for this product and the contents of the user manual are subject to change without notice.
ABOUT OREGON SCIENTIFIC
Visit our website (www.oregonscientifi c.com) to learn more about Oregon Scientifi c products. If you’re in the US and would like to contact our Customer Care department directly, please visit: www2.oregonscientifi c.com/service/support
OR
Call
For international inquiries, please visit: www2.oregonscientifi c.com/about/international
Hereby, Oregon Scientifi c, declares that this METEO Weather Forecast Watch (Model RA121) is in compliance with EMC directive 89/336/CE. A copy of the signed and dated Declaration of Conformity is available on request via our Oregon Scientifi c Customer Service.
METEO
Montre station météo
MODELE : RA121
MANUEL DE L’UTILISATEUR
FR
INTRODUCTION
Nous vous remercions d’avoir choisi la METEO montre station météo (RA121) de Oregon Scientifi c. Equipée des fonctions horloge, chronomètre, alarme;
IMPORTANT
•Les fonctions de mesure de l’appareil RA121 ne doivent pas se substituer aux dispositifs de précision industriels ni aux mesures effectuées par des professionnels. Les relevés enregistrés par cet appareil doivent être considérés uniquement comme des représentations plus ou moins précises.
•Oregon Scientifi c ™ ne peut être tenu responsable de la perte de la montre ni des réclamations de tierces parties relatives à son utilisation.
TOUCHES DE COMMANDE
1 | 3 |
| 4 |
2 | 5 |
1.MODE : Permet de passer à un autre mode, de sortir rapidement du mode de réglage
2.SET : Permet d’entrer dans le mode réglage ou de confi rmer les valeurs d’un réglage
3.ST/SP/ + : Permet d’augmenter la valeur d’un réglage, de lancer/arrêter le chronomètre
4.
/ 
: Active le
5.RST /
ECRAN LCD
1 |
|
2 |
|
3 | 5 |
4 | 6 |
|
7
8
1.Affi chage des prévisions météo
2.
: Indique que les touches sont verrouillées
3.
: Indique que le bip est désactivé
4.Affi che l’horloge, le calendrier, le chronomètre, l’heure de l’alarme ou les bannières des modes
5.
: Indique que l’alarme est activée
6.
: Indique si le chronomètre s’affi che ou est en fonctionnement
7.
: Horloge format 12 H
8.
ou 
: Indique que la pile est faible
AU COMMENCEMENT
METTRE EN MARCHE L’APPAREIL (UNIQUEMENT LORS DE LA PREMIÈRE UTILISATION)
Appuyez sur n’importe quel bouton pendant 2 secondes pour activer l’écran LCD.
REMPLACER LA PILE
Le modèle fonctionne avec une pile au lithium CR2032, d’ores et déjà installée. Voir
INDICATION DESCRIPTION
La pile de la montre est faible.
S’affi che lorsque la pile est trop faible pour fonctionner.
Les icônes de prévisions météo ne s’affi chent pas.
REMARQUE Si l’icône de faiblesse des piles s’affi che, les fonctions de prévisions météo, de bip de l’alarme et du rétro- éclairage seront désactivées. Elles reviendront en mode normal une fois les piles remplacées.
REMARQUE Si vous devez remplacer la pile, nous vous recommandons de contacter le distributeur ou le service clientèle.
Pour remplacer la pile :
1.Utilisez un petit tournevis pour retirer le couvercle du compartiment des piles. Une fois ouvert, placez les vis dans un endroit où vous êtes certain de les récupérer.
2.Remplacez la pile usagée et insérez la nouvelle en respectant les signes de polarité.
3.Replacez le couvercle en serrant les vis à l’aide du tournevis .
MODES DE FONCTIONNEMENT
Appuyez sur MODE pour alterner entre :
•Mode Heure
•Mode Date
•Mode Chronomètre (Chrono)
•Mode Alarme
MODE HEURE
Vous pouvez utiliser ce mode pour visualiser l’heure, les prévisions météo et pour régler l’heure et la date.
POUR RÉGLER L’HEURE ET LA DATE
1.Appuyez sur MODE pour naviguer dans le Mode Heure.
2.Appuyez et maintenez la touche SET pour avoir accès aux réglages.
3.Appuyez sur ST/SP/+ ou RST/- pour modifi er les réglages. Appuyez et maintenez ST/SP/+ ou RST/- pour modifi er rapidement les valeurs.
4.Appuyez sur SET pour confi rmer le réglage et passer au suivant. Recommencez les étapes 3 et 4 pour chaque option de réglage. Les options de réglage se présentent de la manière suivante : Heure : format 12 ou 24 h ; heure ; minute ; année ;
5.Appuyez sur MODE pour confi rmer et sortir.
MODE DATE
Utilisez ce mode pour visualiser la date actuelle et les prévisions météo. Appuyez sur MODE pour naviguer dans le Mode Date.
MODE CHRONOMETRE (CHRONO)
POUR LANCER / ARRÊTER LE CHRONOMÈTRE
1.Appuyez sur MODE pour naviguer dans le Mode Chronomètre.
2.Appuyez sur ST/SP/+ pour mettre en marche le chronomètre.
REINITIALISER LE CHRONOMETRE
Appuyez sur RST/- pour réinitialiser le chronomètre.
