Oregon Scientific RM622PA Setting The Clock Manually, Activating / Deactivating The Rf Signal

ACTIVATING / DEACTIVATING THE RF SIGNAL

1.To activate the RF signal, press and hold for 2 seconds.

2.To deactivate the RF clock reception, press and hold ZONE for 2 seconds.

NOTE The RF signal icon appears on the LCD when

it is activated and disappears when it is deactivated. If the clock cannot recive any signal reception, appears

instead of . See section on "Troubleshooting" for more

information.

SETTING THE CLOCK MANUALLY

The 12-hour clock automatically sets itself to the U.S. Atomic Clock - it never needs adjusting for Daylight Saving Time. The top line of the clock display shows hours, minutes and seconds / day-of-the-week. To toggle between seconds and day-of-the-week display, press MODE. The second line shows calendar (month and date) / alarm time and indoor temperature.

To adjust the clock settings manually without automatic RF synchronization, remember to deactivate the radio reception first.

Each of clock settings can be adjusted in the following order: hour, minute, year, month, date, and language (E, S, F).

1.Press and hold MODE for 2 seconds. The first clock setting, the hour setting, begins flashing.

2.Press or to adjust the hour values. To choose the values more quickly, press and hold or continuously.

3.To confirm and save the desired hour value, press MODE. The next clock setting, the minute setting, automatically begins flashing.

4.Repeat steps 2 and 3 to adjust the clock minute values and the other clock settings accordingly.

5.After adjusting the hour and minute, you may decide to skip adjusting the minute, year and month, and go directly to adjust the date settings. To skip any setting, press MODE to navigate through the items until you reach the desired setting.

NOTE When adjusting the date on the second line of the LCD, the corresponding day-of-the-week shown on the LCD’s top line will change automatically.

NOTE The time is shown only in 12 hr AM/PM format. 24 hr format is not available in this unit.

NOTE During anytime you are in the middle of adjusting a clock setting manually and is left idle for 1 minute, the clock automatically saves the current setting chosen.

EN

5