8BASIC OPERATION
Once you have set up your Baby Monitor, you will be able
to hear the sounds in your baby's room through the Parent
Unit. And also see the green and red sensor lights around
the top of the Parent Unit rise and fall with the sound levels.
Note:
If the connection between the Parent and Baby Units is
broken at any time the green Link light on the Parent Unit
will fl ash slowly, the parent unit will beep to alter you that
the link has been lost and the green and red sensor lights
will cease to react to any sounds. Move closer to the baby
unit or follow the directions in "Troubleshooting" chapter to
re-establish the link.

Power On/Off

Once connected to the power supply,
• Press [ ] on each Unit to turn on the power.
• To switch off, press and hold the [ ].

Monitoring

• Position the baby unit accordingly. It should be
placed 1 metre to 1.5 metres away from the baby's
cot on a fl at surface.
• Take the parent unit to monitor.
• Audio picked up by the baby unit microphone is
depicted on the 8 lights on the parent unit (5 green
and 3 red). The more audio is picked up, the more
lights will be lit. When no audio is picked up, all 8
lights will be off.
• If the volume of the Parent Unit is turned off, an alert
will sound when the audio reaches the second red
led.
Note:
Do not position the baby unit and the parent unit close to
each other as feedback may be generated.

Adjusting Volume

You can adjust the volume at which you hear your baby.
There are 5 volume levels and an Off setting on the
Parent Unit.
Press [ ] to increase the volume and [ ] to decrease
the volume. When adjusting the volume, the 5 green sound
sensor lights will illuminate to indicate the volume level.

Paging

If the Parent Unit is misplaced, you can use [ ] button on
the Baby Unit to locate the Parent Unit.
• Press and hold [ ] on the Baby Unit. The Parent Unit will
automatically reset to mid volume and the paging alert will
sound.