3.1Turning the AM880 ON and OFF

To turn on the AM880, press ON/OFF/STOP button. The PLAY LED illuminates and the AM880 is ready to answer calls.

To turn it off, press ON/OFF/STOP button. The play LED turns off.

3.2Recording outgoing messages (OGM) The AM880 has two prerecorded outgoing messages:

1.An outgoing message that says ‘Hello, please leave a message after the tone’. If the ANS/ANNC ONLY switch is set to ANS, the AM880 will play this message to your callers unless you record your own.

2.Announce-only outgoing message that says “No one is available to take your call”. If the ANS/ANNC ONLY switch is set to ANNC ONLY, the AM880 will play this message to your callers unless you record your own.

To record your own OGM (up to 5 minutes in length):

1.To record an outgoing message, slide ANSN/ANNC ONLY switch to ANS.

To record an announce-only outgoing message, slide ANS/ANNC ONLY switch to ANNC ONLY.

2.Press and hold / OGM button and the AM880 beeps. The display shows ‘OGM RECORDING’ and the counter starts counting up.

3.Speak clearly at a distance of about 15 cm (6 inches) from the microphone.

4.Release the / OGM button when you have finished speaking. Your OGM will be played back automatically and the display shows ‘OGM PLAYBACK’.

Notes:

To change your OGM, repeat steps 1-4 above.

Each outgoing message can be recorded, played back, or deleted independently.

The maximum recording memory of your answering system is approximately 50 minutes. The length of your message will reduce the total recording time available for incoming calls. For example, a 20-second message will leave approximately 49 minutes and 40 seconds recording time.

To check your OGM at any time, press and release the / OGM button.

If you record your own message and subsequently decide to use the prerecorded message, press / OGM button, then while your own message is playing, press DELETE button.

4

Page 5
Image 5
Oricom warranty Turning the AM880 on and OFF, To record your own OGM up to 5 minutes in length