Oricom M5050 Your Oricom M5000 Handset, Register a handset, Make a handset call, Answer a call

ABOUT YOUR PHONE

2 Setting up your phone

Basic steps to setup

1.Plug the mains power adapter of the charger into the wall mains supply.

2.Insert the two AAA batteries observing the correct polarity, into the battery compartment on the handset.

3.Slide the battery door firmly into place.

4.Place the handset on the base unit or the charger and let the batteries charge for a full 14 hours before using. Handset may get warm during initial charge. This is normal.(Ensure wall mains supply is switched ON)

5.Register the handset to the base unit. (Refer to ‘Register Handsets’ section for details.)

Note: Before you can use this handset. You need to:

1.Charge the batteries (for 14 hours).

2.Register the handset (to the Base unit).

3 About your phone

Your Oricom M5000 Handset

ABOUT YOUR PHONE

4 Registering Handsets

Note: Before you can use this handset. You need to:

1.Charge the batteries (for 14 hours).

2.Register the handset (to the Base unit).

Register a handset

This handset is GAP compatible. You must go through the registration process with a base unit in order for it to operate. Each handset can register to one base at a time only. The current base will be deregistered when a new base is registered. If you register the handset with another manufacturer’s base unit, some features may not be available.

(The following procedure may not apply if the base unit is from another manufacturer. Please refer to the instruction manual of the base unit.)

Ensure no handset is resting on the base unit’s charging cradle:

1.Press & hold HANDSETLOCATOR button on the BASE UNIT for 10s until the IN-USE light flashes (you have 3 minutes to register handset).

2.Key in a base unit number 1, 2, 3 OR 4, If you have one base unit key in 1.

3.Key in your handset’s PIN code default 0000.

4.Handset now registered. You will hear a tone + display shows a handset number.

PHONE button

Arrow LEFT /

RECALL button

MEMORY button

Speaker button

Ringer ON / OFF button

VOLUME button for earpiece & ringer

	Arrow RIGHT
	/ CALLER
	DISPLAY
	button
DEL	MUTE /
	DELETE
	button
	INTERCOM
	button
	Keypad
	LOCK/
	UNLOCK
	LAST NUMBER
	redial

5 Making Calls

Note: OUT-OF- RANGE warning

You may be out-of-range with the BASE UNIT if you hear a warning tone or the sound becomes distorted. Either

1.Move handset closer within 20 seconds until the tone stops. Otherwise, your call may be cut off.

2.Reposition & reconnect BASE UNIT to a phone connection closer to where the handset will be used (an extension lead(s) for power & telephone line may be useful where necessary).

Make a handset call

1.Key number into telephone.

2.If necessary, press MUTE/DEL to clear single digit or Press & Hold MUTE/DEL to clear all digits

3.Press PHONE button to dial.

4.if necessary, press LAST NUMBER REDIAL button.

Answer a call

When the handset rings:

1.Press PHONE or SPEAKERPHONE button.

Note: Call timer - The call timer shows the duration of your current call on display.

End a call

1. Press PHONE or SPEAKERPHONE button. The symbol disappears from the display.

M5050 User guide.doc Page 3 of 6 M5050 User guide.doc Page 4 of 6