-Operation-
3.8 Fitting the desk support
If you intend to use your telephone on a desk, then the desk support supplied
must be fitted. To do this, turn the telephone over. Now insert the two upper
hooks into the openings provided and push the desk support firmly home.
If you ever need to remove the support, press gently on the middle clips on the
upper edge and then pull the desk support off.
In the handset rest there is a small hanging device, which is used when the
telephone is wall mounted. This hanging device is not required when the
telephone is used on a desk, as it impedes lifting of the handset. Using a small
screwdriver, turn this hanging device until the screw is completely flush and its
upper end does not protrude at all.
3.9 Wall mounting
Your telephone is also suitable for wall mounting. Use two screws for fixing. Drill
two holes horizontally side by side, 70mm apart, and leave the screws
protruding from the wall by 5mm. Now place the telephone over the screws and
push it slightly downwards.
There is a small hanging device in the handset rest to prevent the handset from
falling when it is placed on the rest with the telephone mounted on the wall.
Using a small screwdriver, turn this hanging device until a small hook appears
at the upper end.
If you are using the telephone fitted to the wall, you can hang the handset on
the telephone without hanging up. You will find a small hook for this purpose at
the upper end of the handset rest.
3.10 Adjusting display contrast
To adjust the display to suit the local lighting conditions, please proceed as
follows:
1. Press the DIAL/MENU button for 3 seconds. The display shows
“OPTIONS cd”.
2. Press the c buttons until the display shows “LCD CONTRAST”.
3. Press the DIAL/MENU button to enter setup mode.
4. Now select the desired contrast between 0 to 7 using the d and c
buttons.
5. Confirm with DIAL/MENU button.
6. Press RECALL button to exit menu.