3 Installation
3.1 Check contents of pack
The following items are supplied in this pack:
one telephone base | one telephone handset |
|
|
one short telephone cable | one curly cord |
|
|
one long telephone cable | one operating Manual |
|
|
one warranty card |
|
|
|
3.2 Connect the handset and line cord
Connect the telephone handset to the base unit. Plug one end of the curly cord into the socket on the handset. Locate the socket on the base of the phone and plug the other end of the curly cord into this.
Plug one end of the telephone cable (long for desk installation) into the wall socket. Plug the other end into the socket located in the indentation on the base of the telephone. Then feed the cable through the cable guide.
3.3 Wall mounting
Method A. Use two screws for fixing. At the desired location drill two holes one above the other, 83mm apart, and leave the screws protruding 5mm from the wall. Now place the telephone base over the screws and gently push forwards and then downwards.
Method B. If you wish to fit to an existing telephone wall plate with modular connector. Plug the short telephone line cord supplied into the base of the phone; plug the other end into the telephone wall plate socket. Position the mounting holes on the base of the phone over the two protruding screws on the wall plate. Gently push the phone flush against the wall plate then slide the phone downwards locking it into place.
3
