Oricom W1 manual Basic steps to install

Basic steps to install

1.Connect the output plug of the mains adaptor to the adaptor socket on the back of the base unit and the mains adaptor to the wall mains supply.

2.Connect the telephone lead to the phone cord socket on the back of the base unit and to the wall phone socket.

3.Insert 2AAA Ni-MH rechargeable batteries (supplied) into each handset, observing the correct polarity, into the battery compartment on the handset. (Figure 1)

4.Before placing the battery door back on the handset, make sure there is no foreign matter under the rubber seal located on the under side.

5.Place the battery door back into place and tighten the 2 screws provided. (Figure 2)

6.Place the handset on the base unit and let the batteries charge for a full 14 hours before using.

7.To attach belt clip Turn the handset over. Align the belt clip with the holes on the both sides of the handset. Press into place

Figure 1

Figure 2

This phone is not fully weather-sealed or waterproof. Its special construction provides protection against splashes and dripping water. Any water or liquid exposure other than the above may result in serious damage to the phone. THE BASE AND CHARGE POD ARE NOT WATER RESISTANT. ALWAYS WIPE DRY A DIRTY OR WET HANDSET BEFOR PUTTING IN CHARGE BASE.

7