Oricom W1 manual Deregister, PIN code, Reset

3.Before you enter the PIN, press and hold on the base for 2 seconds until a registration tone is emitted. The base is now in the registration mode. (If the base is full and cannot take on any more handset, it will emit a reject tone instead. See the section of Deregister to delete a currently registered handset.)

4.Enter the PIN of the base and press OK .

You will hear a confirmation tone if the registration is successful. The handset label and the handset number will be displayed.

If the registration is not successful, you will see NOT REG on the handset. Follow the procedure and try again.

Deregister

A handset can deregister another handset registered to the same base. It cannot deregister itself.

1.Press PROG during standby follow by the 9 key.

2.Enter the handset number (i.e. HS#2) to delete. The LCD will display 9-2.

3.Press OK and then

4.Enter the PIN

5.Press OK to confirm.

PIN code

A PIN is required for registration and deregistration. The ex-factory PIN is 0000 but you can change this code.

1.Press PROG during standby follow by the 8 key.

2.Enter the current PIN and press OK .

3.Enter the new PIN. It can contain from 0 up to 8 digits. Press OK .

4.Repeat the new PIN and press OK to confirm the new code. You will hear a confirmation tone if it is successful, or a reject tone if the same PIN is not entered.

Reset

If you reset the phone, all the settings will return to the factory default settings.

1.Press PROG during standby. Then press and hold MUTE until RESET is displayed.

2.Press OK to confirm the action.

You cannot reset the phone if the handset has lost link with the base. UNAVAIL will be displayed. Re-establish the link and try again.

17