Manuals / Orion Car Audio / Car Audio and Video / Car Amplifier

Orion Car Audio HCCA-D1200, HCCA-D2400, HCCA-D5000 General Precautions and Installation Tips

Models: HCCA-D5000 HCCA-D2400 HCCA-D1200 HCCA-D1200, HCCA-D2400, HCCA-D5000

1 25
Download 25 pages 62.86 Kb
Page 15
Image 15

General Precautions and Installation Tips

WARNING! Be careful not to cut or drill into gas tanks, fuel lines, brake lines, hydraulic lines, vacuum lines, or electrical wiring when working on your vehicle.

Disconnect the vehicle's ground wire at the battery before making or breaking connections to the audio system's power supply terminals.

Do not use this amplifier unmounted. Failing to securely mount the amplifier can result in damage or injury, particularly in the event of an accident. An unmounted amplifier becomes a dangerous projectile in the event of a crash. Never mount the amplifier where it might get wet. Mount the amplifier so the wire connections will not be pulled. Route the wires where they will not be scraped, pinched or damaged in any fashion.

The +12V power supply wire must be fused as close as possible to the battery terminal, ide- ally within 18". Use the recommended fuse size or circuit breaker listed in the Power Connections section of this manual.

If you need to replace the fuse plugged into the side of the amplifier, replace the fuse with the same size and type fuse that came with the amplifier. If you are not sure as to the correct value, refer to the Power Connections section of this manual for details. Using a higher cur- rent fuse may result in damage to the amplifier that is not covered under warranty.

NOTE: Make sure all the equipment in the system is turned off when making or break- ing connections to the input RCAs or speaker terminals. Turn on the system and slowly turn up the volume control only after double checking all wire connections.

Power for systems with a single amplifier can be supplied by most automotive electrical sys- tems. Systems with multiple amplifiers may require a higher capacity battery, alternator or the use of a storage capacitor. We strongly recommend the use of a Directed Audio Essentials power capacitor with an extra battery in larger stereo systems.

Orion amplifiers generate a certain amount of heat as part of normal operation. Be sure the area around the amplifier is unobstructed to allow adequate air circulation. Remember, beach blankets, last week's laundry, school books and homework papers located on top of the amplifier do not improve air flow and may become damaged.

Tools of the Trade

Listed below are the majority of the tools required to perform an installation. Having the proper tools will make the installation that much easier. Some of these tools are necessities; some will just make the job easier.

●Allen Wrenches (2.5mm and 3mm)

●DMM or VOM

●Electric drill with assorted drill bits

●Grommets

●Heat shrink tubing

●Marking pen

●Nylon tie straps

●Phillips and flat blade screw drivers

●Pliers (standard and needle nose)

●Reference CD with 1 kHz Sine Wave at 0dB level (all bits high)

14

© 2005 Directed Electronics, all rights reserved

Page 14 Page 16
Page 15
Image 15
Orion Car Audio HCCA-D1200, HCCA-D2400, HCCA-D5000 manual General Precautions and Installation Tips, Tools of the Trade
Page 14 Page 16

HCCA-D5000, HCCA-D2400, HCCA-D1200, HCCA-D1200, HCCA-D2400, HCCA-D5000 specifications

Orion Car Audio has long been a respected name in the car audio industry, known for producing powerful and high-quality amplifiers. Among its standout products are the HCCA-D1200, HCCA-D2400, and HCCA-D5000 amplifiers, each designed to deliver exceptional performance and clarity in audio reproduction.

The Orion HCCA-D1200 is a formidable amplifier that offers a power output of 1,200 watts RMS at 1 ohm. It is tailored for those seeking a robust sound system that prioritizes low-frequency performance. This model features a high-efficiency Class D design, enabling it to transmit clean power with minimal distortion. With adjustable gain control, low-pass and subsonic filters, users can easily tailor the sound to suit their preferences.

Moving up in the lineup, the HCCA-D2400 stands as a powerhouse capable of delivering 2,400 watts RMS at 1 ohm. This amplifier is built with a heavy-duty heat sink and high-quality internal components, ensuring durability and reliability even under heavy loads. The HCCA-D2400 is designed with an advanced PWM MOSFET power supply, enhancing the overall efficiency. Its comprehensive crossover system allows for precise audio tuning, catering to both casual listeners and audiophiles.

For those who demand the ultimate in power, the HCCA-D5000 is a top-tier choice. This beast of an amplifier provides an astounding 5,000 watts RMS at 1 ohm, making it ideal for competitive setups and serious bass enthusiasts. The HCCA-D5000 features an ultra-efficient design that minimizes power loss, paired with a low-level input sensitivity that maximizes compatibility with various signal sources. Its built-in protection circuitry safeguards against overheating and short circuits, adding a layer of reliability.

All three models emphasize Orion’s commitment to high-quality construction and innovative technology. They utilize a unique low-frequency response, ensuring that bass notes are rendered with depth and clarity. Together, the HCCA-D1200, HCCA-D2400, and HCCA-D5000 represent an impressive lineup, catering to clients with varying needs and preferences.

Whether enhancing a daily driver or building a competition-grade sound system, the Orion HCCA series amplifiers provide the power, clarity, and reliability that enthusiasts demand. With their striking performance characteristics and user-friendly features, they embody the essence of what Orion Car Audio stands for in the competitive landscape of car audio equipment.