Orion Car Audio P6.2, P5.2 manual Flush Mounting Into Removed Panels diagram a

FLUSH MOUNTING INTO REMOVED PANELS (diagram A)

Step 1:. Determine the tweeter mounting location, then route the wires from the crossover to the tweeter location.

Step 2: Mark the center point of the tweeter location.

Step 3: If using a hole saw, first drill a pilot hole, then cut out the hole using a standard 2-1/8" hole saw.

Step 4: If not using a hole saw, use either the cardboard packaging for the tweeters or the surface mount trim ring as a template to mark the proper size hole. Cut out the hole.

Step 5: With the tweeter assembled, route the wires through the hole and the pressure ring and slip the pressure ring over the tweeter assembly.

Step 6: Align the tweeter so the logo faces the desired direction then push the pressure ring on to the rear of the tweeter assembly until the tweeter is snugly mounted to the panel.

Step 7: Connect the speaker wires observing the correct polarity and re-assemble the panel.

FLUSH MOUNT TWEETER ASSEMBLY

PRESSURE RING

FLUSH MOUNT TRIM RING

TWEETER

HEX HEAD BOLT PANEL

X-BRACKET

DRW-12

TWEETER WIRE

A

WIRING HARNESS

B

DRW-68

TWEETER WIRE

FLUSH MOUNT HOUSING

WIRING HARNESS

FLUSH MOUNTING INTO MOUNTED PANELS (diagram B)

Step 1: Determine the tweeter mounting location, then route the wires from the crossover to the tweeter location.

Step 2: Mark the center point of the tweeter location.

Step 3: If using a hole saw, first drill a pilot hole, then cut out the hole using a standard 2-1/8" hole saw.

Step 4: If not using a hole saw, use either the cardboard packaging for the tweeters or the surface mount trim ring as a template to mark the proper size hole. Cut out the hole.

Step 5: Remove the tweeter from the flush mount housing and insert the proper length machine bolt through the center hole of the housing and connect to the spring steel X-bracket. (See Figure 3.)

Step 6: Connect the speaker wires observing the correct polarity.

Step 7: Press the X-bracket portion of the assembly through the hole until its legs spring open.

Step 8: Screw the bolt in until the tweeter housing is firmly mounted to the panel. (Make sure the arrow at the rear of the tweeter housing is pointing in the desired direction.)

Step 9: Insert the tweeter into the housing and attach trim ring.

5