Orion Car Audio P5.2, P6.2 manual Installing the Tweeter, Surface Mounting

Step 9: Mount the speaker- The speaker is placed in the grille ring from the front. Place the speaker and the grille ring in the installa- tion hole. Align the mounting screw holes and drive in the four mounting screws. Push the perforated metal grille back into the grille ring.

INSTALLING THE TWEETER

SURFACE MOUNTING

Step 1: Determine the tweeter mounting location, then route the wires from the crossover to the tweeter location.

Step 2: Place the surface mount housing against the panel and mark the two holes at the rear of the housing.

Step 3: Drill the smaller center hole using a 1/8" drill bit. This is the mounting screw hole.

Step 4: Drill the larger off-center hole using a 3/8" drill bit, insert a grommet and route the speaker wire from the crossover through the grommet.

Step 5: After removing the surface mount tweeter assembly trim ring, route the tweeter wires through the larger hole in the housing and connect to the speaker wires from the crossover. (See Figure 4.)

Step 6: Insert the excess speaker wire into the hole and position the housing so the housing will not pinch the wires after final mounting.

Step 7: Attach the housing using the supplied screws of the correct length for a solid mount.

Step 8: Insert the tweeter into the housing and attach the trim ring.

4