Orion Car Audio XTR1002 owner manual Installing the Crossover, To Tweeter

INSTALLING THE CROSSOVER

There is a tweeter level jumper for adjusting the tweeter. Cutting this jumper will change the output gain of the tweeter. Where the adjustment should be depends on the location of the tweeter and your preference. Adjustments can be made from 0dB to -3dB by cutting the "level jumper". Tweeter phase can be changed by reversing the polarity of the amplifier output wire connections to the crossover. If the tweeter is within 6" of the woofer center the tweeter should be in phase with the woofer. If the tweeter is further than 6" from the center of the woofer, both in phase and out of phase should be tried to see which is best.

Use wire tie or screws to secure crossover housing in place.

Figure 3	To Tweeter
Figura 3
Abbildung 3

-

+

Level jumper

Crossover

Note: Jumper is under top cover of crossover housing.

Remarque : Le cavalier se trouve sous le couvercle du boîtier du filtre.

Nota: El puente está debajo de la tapa de arriba del alojamiento del crossover.

Hinweis: Der Jumper befindet sich unter dem Deckel des Crossover-Gehäuses.

Nota: il ponticello si trova sotto il coperchio superiore del supporto del crossover

Nota: O jumper está embaixo da tampa superior da carcaça do crossover.

Amplifier

+

_

Note: The tweeter positive is the wire marked with the stripe.

Note: Le câble positif du haut-parleur d'aigus est rayé.

Nota. El positivo del tweeter es el cable que tiene la franja.

Hinweis: Der positive Hochtönerdraht ist mit dem Streifen markiert.

Nota: il filo positivo del tweeter è contrassegnato da una striscia.

Nota: O cabo positivo do tweeter está marcado com a listra.

6 © 2008 directed electronics—all rights reserved