INSTALLING THE TWEETERS
SURFACE MOUNTING
Step 1: Determine the tweeter mounting location, then route the wires from the crossover to the tweeter location.
Step 2: Place the provided template or tweeter cup against the panel and mark the two holes at the rear of the housing.
Step 3: Drill the smaller holes using a 1/8" drill bit. These are the mounting screw holes.
WARNING: Check for clearance of window mechanisms and electrical wires BEFORE you drill.
Step 4: Drill the larger
Step 5: After removing the surface mount tweeter assembly trim ring, route the tweeter wires through the larger hole in the housing and connect to the speaker wires from the crossover.
Step 6: Insert the excess speaker wire into the hole and position the housing so the housing will not pinch the wires after final mounting.
Step 7: Attach the housing using the supplied screws of the correct length for a solid mount.
Step 8: Insert the tweeter into the housing and attach the surface mount trim ring.
SURFACE | MOUNTING SCREWS |
MOUNT |
|
TRIM RING |
|
|
|
SURFACE MOUNT HOUSING
Figure 1 |
|
Figura 1 |
|
Abbildung 1 | TWEETER |
TWEETER WIRE
PANEL
WIRING HARNESS
4 | © 2008 directed |
