PARTS IDENTI FICATIO N
Before using your Deep Fryer for the first time, you should become familiar with all of the parts. Read all Instructions and Safeguards carefully.
USING YOUR OSTER DEEP FRYER
NOTE: Never plug in fryer with an empty Oil Reservoir. Always use your fryer on a flat, heat resistant surface.
Lid | Filter Cover |
Lid Button
•Attach magnetic end of Sure Release power cord assembly directly to the fryer. This should be done prior to plugging the cord into the wall outlet. The magnetic end of the cord is designed only to go on one way. Be sure the side stating “THIS SIDE UP” is facing up. (See Figure 1)
•Open Lid by pressing the Lid Button.
•Remove Frying Basket.
•Pour cooking oil into Oil Reservoir until it reaches between “MIN” and “MAX” marks inside reservoir. DO NOT OVER OR UNDER FILL. Place the Frying Basket back into Fryer in the upper position by hooking over oil reservoir. (See Figure 2)
•Close Lid.
•Insert plug into 120 volt AC outlet.
•The power light will come on and the Fryer will begin heating.
•Turn the fryer to desired temperature position.
| P |
ISSIDE | U |
| |
TH |
|
Figure 1
Raise | Hook |
| |
Lowe | r |
|
Figure 2
Main Housing
Power Indicator
Handle | Slide Switch | Sure Release Power Cord |
|
| (not shown) |
•For best results, wait 20 minutes for the oil to reach cooking temperature. Open Lid by pressing the Lid Button.
CAUTION: Escaping steam is hot! Be careful when opening lid.
•With the Frying Basket in the upper position, place food inside Frying Basket (Do not over stack food). Close Lid. Lower the basket into oil by lifting it up off hook and setting down into the oil.
CAUTION: Always replace and close Lid before immersing food in oil. Do not immerse or drain food with Lid removed or open. Disconnect Plug from wall.
WARNING: DO NOT USE SURE RELEASE POWER CORD SYSTEM TO DISCONNECT THE FRYER. ALWAYS DISCONNECT PLUG FROM WALL OUTLET FIRST TO DISCONNECT FRYER.
Use only Model #PL1215 magnetic cord set with this product. The use of any other magnetic cord set may cause fire, electric shock, or injury.
CAUTION: The Sure Release Power Cord is only for accidental disconnection and is not to be removed during normal operation. If the cord becomes disconnected, the user should immediately unplug the cord set from the wall outlet, then reconnect. (See Figure 1)
