Grounding Instructions
•The FW-X240’s metal mounting bracket must be connected to a permanently grounded system. System grounding as required by the National Electric Code, ANSI /NFPA 70-1996, is the responsibility of the system installer.
•The FW-X240 hardware kit includes grounding washers to penetrate a powder-coated fi nish, assuring a proper ground connection to any FLEXware enclosure or mounting plate.
•An installation might call for an optional grounding wire between the FW-X240 and the FLEXware enclosure or mounting plate to which it’s attached depending on local code requirements or the nature of the installation itself.
Connections
•No additional terminals or lugs are required for hook-up of the AC wiring.
•AC wiring must be no less than 10 AWG gauge copper wire, rated for 75 degrees C or higher and must be sized appropriately to the circuit breaker.
Hardware Kit
The FW-X240 comes with four M6 X 20 mm screws, four fl at washers, and four grounding washers for mounting to a FLEXware Mounting Plate from inside a FLEXware AC enclosure.
