Outback Power Systems FW-X240 installation manual Important Safety Instructions

Welcome to the OutBack Power Systems FW-X240 Auto Transformer

The FW-X240 Auto Transformer can be used for step-up, step-down, generator and split phase output balancing or with series-stacked FX or VFX Series Inverter/Chargers for inverter balancing.

OutBack Power Systems does everything possible to assure the components you purchase will func- tion properly and safely when installed as instructed according to local and national electrical codes (NEC). Please read all of the following instructions and the instructions that come with any other OutBack components that make up your power system.

The FW-X240 Auto Transformer Specifications:

•120 volt/25 amp primary and secondary side

•120 or 240 VAC 60 Hz systems only

•Allows powering 240 volt items ( e.g., a deep well pump) with a single 120 volt AC source

•Step-down feature allows battery charging with both legs of a 240 volt generator through a single 120 volt FX Series Inverter/Charger

Two identical windings:

•Winding one is between leads #1 and #2

•Winding two is between leads #3 and #4

•The start for each winding are on lead #1 and on lead #3

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS

Please read all instructions and cautionary markings on the FW-X240 and other system components and their instructional manuals.

To reduce risk of electric shock:

•Disconnect all DC and AC power sources before attempting any maintenance or repair.

•The input side of the AC and DC breakers may be live even though the breakers are off.

•Be sure to test all terminals with a voltmeter before touching or using any tools.

•Always use caution when using metal tools to prevent contact with live parts or terminals.

•All installations must be in compliance with all local and national electrical codes and standards.

3