Installation Instructions
Model AMPIC5 / AMPIC6
(UL Listed)
AMPIC5 / AMPIC6 carton includes the following items:
1.One (1) each AMPIC5 or AMPIC6
2.One (1) each UL Listed Power Supply
( IC5/IC6, Tile Bridge, Backcan and Volume Controls are Optional – Sold Separately)
Introduction:
The AMPIC5/AMPIC6 is designed to provide an OWI 5.25” (IC5) or 6.5” (IC6) speaker that is self powered allowing line input audio that is either balanced or unbalanced to provide the input signal. The power amplifier provides up to 25 watts of power. It has enough power to allow up to a total of four
Specifications: |
|
Model Number | AMPIC5 / AMPIC6 |
Frequency Response | 50 Hz to 15 kHz. HF is optimized to enhance frequency |
| response of the speaker. |
THD | <.1% |
S/N | >90dB |
Input Configuration | Differential (noise reducing) |
Minimum Common Mode Rejection | 40dB |
Maximum Power Output | 25 Watts |
At load impedance | 4 Ohms (2 speakers in parallel or 4 speakers in series parallel) |
Minimum Power Supply Voltage | 8 Volts |
Maximum Supply Voltage | 14 Volts |
Maximum current protected | Yes |
Short Circuit protected | Yes |
One wire to ground protected | Yes |
Minimum Load Impedance | 3.2 Ohms |
Input Load Impedance | 10K Ohms |
Plastic | Fire rated |
Maximum number of Amplifiers on one line | 20 |
Available Backcan (Sold Separately) | UL Listed and Plenum rated |
Available Tile Bridge (Sold Separately) | Support Truss |
Warranty | 1 year |
Page 4 of 16 | Filename:AMPIC5_6 MANUAL |
| 07/18/08 |