Trouble Shooting Guide
1.No output: Disconnect any secondary speakers and check for operation of the primary speaker only. If still there is no output, check for loose screws on the green input connector. It is easy to think the wires are secured in the connector and one wire is not. Tug on each wire to make sure each is tight.
2.Intermittent output: Check for shorted output causing the amplifier to into and output protection. Check each input wire for loose screws.
3.Distortion: Do not power more than one AMPIC5/6 on one power supply. While it will work, it will cause distortion.
4.No output, check to see that the power on light is on. It is located on the main PCB. If it is off, the power supply is either bad or has come loose in the power socket.
5.Hum, for single ended inputs, there is a need for a jumper between – and the ground screw. Most of the time, the jumper is needed.
LIMITED WARRANTY
1.The AMPIC5/6 product has been thoroughly tested and inspected at the factory. It is warranted for one (1) year from date of purchase.
IT IS THE OWNERS’ RESPONSIBILITY TO ESTABLISH THE DATE OF PURCHASE BY ACCEPTABLE EVIDENCE AT TIME SERVICE IS SOUGHT.
2.Any unit, which in the judgment of OWI INC. is defective or develops defects under normal use will be replaced or repaired without cost within the warranty period.
3.This warranty will be considered void if unit has been dropped, misused, abused, altered in any manner, overdriven with excessive amplification exceeding manufacturer’s specification, improperly serviced or accidental damage.
4.OWI Inc. shall have no liability whatsoever for consequential damage. The sole responsibility and discretion of OWI Inc. under this warranty shall be limited to the repair of the product or replacement thereof.
5.IMPORTANT: This warranty is void unless the attached card is completed and mailed to OWI Inc. within 10 days following the date of purchase. Units must be sent to OWI Inc. or to the dealer where purchased.
Page 9 of 16 | Filename:AMPIC5_6 MANUAL |
| 07/18/08 |
