Panasonic 1728 manual Fire alarm systems External Presentation unit, LEDs, push buttons etc

Fire alarm systems

External Presentation unit

1728

•For presentation of pre-warnings, fire alarms, faults & disablements

•Compact size

Presentation unit 1728

This unit (S/W V1.2) is intended for pre- warning, fire and heavy smoke / heat alarm

presentation. Point or zone alarm presentation is like in the c.i.e. it is connected to. You can scroll amongst two or more alarms in the system but the fire alarms can not be reset via this unit. All or selected alarms will be presented in a display (LCD, 2x40 characters with back- light). An alarm text will be presented together with each alarm, if programmed in the c.i.e. Furthermore, >617 texts for selected alarms can be stored in the unit and will in such a case be shown, instead of the texts sent from the c.i.e. for these alarms. A built-in buzzer will sound like in the c.i.e. It can be silenced but the alarm devices in the installation can not be silenced via this unit. Any fault in the system will be presented as "General fault in system" and the buzzer will sound. It can be silenced. Any disablement in the system will be presented as "General disablement in system". The unit is power supplied via the c.i.e. or external power supply.

LEDs, push buttons etc.

The unit has the following LEDs:

•Fire (Brand) and Alarms queued (Flera larm), indicating pre-warning,co-incidence and fire alarms.

•Operation (Drift), indicating that the unit is connected to a c.i.e. and power supplied, i.e. it is in operation.

•Extinguishing (Släckanläggning aktiverad), indicating activated output for extinguishing equipment.

•	Ventilation	(Brandventilation
	aktiverad), indicating	activated output
	for ventilation equipment.

•Fire brigade tx (Larmsändare aktiverad), indicating activated output for Fire brigade tx (routing equipment).

The unit has the following push buttons:

•Alarms queued (Flera larm), used to scroll amongst the alarms.

•Silence buzzer (Summer tyst), used to silence the buzzer (it will re-sound for a new alarm).

The designation texts on the front are in 1728SE in Swedish and in 1728UK in English.

Compact size

The compact size enclosure is made of grey high impact ABS. Fitted with a supple- mentary "O" ring gasket, it will comply with IP61, in respect of dust and moisture. The push buttons on the front are disabled until they are supposed to be used. The unit shall be wall mounted. Two compression glands are attached.

SW mode and address setting

The display and the push buttons are used to set the SW mode and address, see the opposite side of this page.

Product application

The 1728 unit is intended for indoor use and in dry premises. SW mode 1728 - 1587 is intended to be used in the systems EBL512 and EBL128 and SW mode 1728 – 1582 in the systems EBL500 / 512 / 1000 / 2000.

Panasonic Electric Works Fire & Security Technology Europe AB Citadellsvägen 23, SE-211 18 Malmö, Sweden

Tel: +46 (0)40 697 70 00 • Fax: +46 (0)40 697 70 99 info-fste@eu.pewg.panasonic.com • www.panasonic-fire-security.com