Panasonic 40RV525R, 40RV52R, 46RV525R Choosing a location for your LCD TV

Choosing a location for your LCD TV

To Display your LCD TV on the included Pedestal

Stand:

Observe the following safety precautions:

1) Read and Follow the pedestal assembly instructions included

with the pedestal.

CAUTION: Before beginning pedestal assembly, carefully lay the

front of the LCD Panel face down on a flat, cushioned surface

such as a quilt or blanket. Leave the bottom of the unit protruding

over the edge of the surface and assemble the pedestal as

indicated below.

Note: Extreme care should always be used when attaching

the pedestal stand to avoid damage to the LCD panel.

2) Place the TV on a sturdy, level surface that can support the

weight of the TV.

3) Be sure to secure the TV to a wall, pillar, surface, or other

immovable structure. ( item 20, page 3).

To Display your LCD TV using a Wall Bracket:

If you decide to wall mount your LCD TV, always use a UL listed wall

bracket appropriate for the size and weight of the LCD TV ( page 2):

1) CAUTION: Two people are required for installation.

2) Unplug and remove any cables and/or other component

connectors from the rear of the TV.

3) Remove the screws of the VESA Mounting Pattern show in

the right diagram.

4) Follow the instructions provided with your wall bracket.

Before proceeding, make sure the appropriate bracket(s) are

attached to the wall and the back of the TV as described in the

instructions provided with the wall bracket.

5) After attaching the appropriate bracket(s) to the wall and the

back of the TV, remove the pedestal stand from the TV as

described below.

6) VESA Mounting Pattern

TV Size Hole Pattern(HxV) Screw Size

40” 200x200 mm M6

46” 400x200 mm M8

(unit in mm)

Removing the Pedestal Stand

1) Carefully lay the front of the unit face down on a flat,

cushioned surface such as a quilt or blanket. Leave the stand

protruding over the edge of the surface.

Note: Extreme care should always be used when removing

the pedestal stand to avoid damage to the LCD panel.

2) Remove the four screws shown in the right diagram. This will

allow removal of the pedestal stand.

3) Once you have removed all four screws holding the pedestal

stand in place, remove the pedestal stand from the TV.

CAUTION: Always place the TV on the floor or a sturdy, level, stable

surface that can support the weight of the unit. To secure the TV, use

a sturdy strap from the hook(s) on the rear of the TV to a wall stud,

pillar, or other immovable structure. Make sure the strap is tight,

secure, and parallel to the floor.

Four screws

40” TV

46” TV

VESA Mounting Pattern

Hook

Sturdy strap

(as short as possible)

Hook

Sturdy strap

(as short as possible)