Panasonic AG-3200P manual Select video input connector, Locate end point, Start editing

BSelect input mode

Select “F-1” —when connecting the other component to the audio/video input connectors on the front panel.

Select “L-1” —when connecting the other component to the audio/video input connectors on the rear panel.

Press AUX or CH+/– on the Remote. Or push the JOG dial, then turn it to the left or right.

CSelect video input connector

Select the appropriate mode depending on the connector being used ( pg. 16).

When using S-VIDEO input connector on the front panel, set “FRONT AUX INPUT” to “S-VIDEO”.

When using S-VIDEO IN connector on the rear panel, set “REAR AUX INPUT” to “S-VIDEO”.

When using VIDEO input connector on the front panel, set “FRONT AUX INPUT” to “VIDEO”.

When using VIDEO IN connector on the rear panel, set “REAR AUX INPUT” to “VIDEO”.

DSelect edit mode

Set the edit mode to “ON” for the VCRs if such a mode is equipped.

●On this VCR, set “PICTURE CONTROL” to “EDIT” ( pg. 14).

ELocate end point

Load the cassette to be edited into the VCR and press PLAY (4), then press PAUSE (9) when you find the end of the scene for which you want to edit.

Press C.RESET so that the counter reading becomes “0:00:00”.

FLocate start point, and engage Insert Editing mode

Press REW (3), then press PAUSE (9) when you find the beginning of the scene for which you want to edit, then press

INSERT.

●The VCR enters the Insert Editing Pause mode. “” and “$” light on the display panel.

●If you want to perform AV Dubbing and replace the picture, Hi-Fi audio soundtrack and normal audio soundtrack all at the same time, after you press INSERT, press A.DUB also.

GStart editing

Load the source cassette and engage the Play mode of the other component, then press PLAY (4) on the VCR. Insert Editing begins at this point.

●Insert Editing stops automatically when the counter reaches “0:00:00”, and the VCR enters the Play mode.

To stop editing any time during recording

Press STOP (8) on the Remote or STOP/EJECT (0) on the VCR, then engage the Stop mode of the other component.

NOTES:

●Insert Editing is not possible with a cassette whose record safety tab has been removed.

●The recording speed (SP/EP) is determined by the previous recording to be replaced. If the recording speed changes on the tape to be edited while editing the tape, the inserted picture will be distorted where the recording speed changes.

●When you edit a tape, a small portion of the recording preceding to the editing start point will be erased from the edited tape.

CONTINUED ON NEXT PAGE

— 20 —