Power sources
Using the battery
Installation
Insert the battery until it clicks into place.
Removal
1 Set the POWER switch to OFF, and check that the mode lamp is off.
Using the AC adaptor
Installation
1 Connect the DC cord to the AC adaptor.
2 Plug the AC power supply cord into the power outlet.
3 Insert the DC cord’s battery connector until it clicks into place.
DC cord’s battery connector
2 Remove the battery while pressing the battery release button.
•Support the battery with your hand to ensure that it will not fall.
Battery release button
WER.
ON CAM MOD
PB
DIOLEVEL CH2
Mode lamp
Preparation
Removal
1 Set the POWER switch to OFF, and check that the mode lamp is off.
2 Remove the DC cord’s battery connector while pressing the battery release button.
3 Disconnect the AC power supply cord from the power outlet.
•Battery cannot be recharged when the DC cord is connected to the AC adaptor.
•Disconnect the AC power supply cord from the power outlet when the unit is not going to be used.
CAUTION:
•This apparatus can be operated at a voltage in the range of 110 – 240 V AC. Voltages other than 120 V are not intended for U.S.A. and Canada.
Operation at a voltage other than 120 V AC may require the use of a different AC plug. Please contact either a local or foreign Panasonic authorized service center for assistance in selecting an alternate AC plug.
25