Adjusting the gain
When the display is dark, increase the gain to brighten the display.
|
| START/ |
| |
|
| STOP 2 |
| |
|
|
| – | + |
FOCUS FUNCTION | USER 1 | DISP/ | POWER.. |
|
MODECHK | MODE | |||
IRIS GAIN WHITEBAL | USER 2 |
| AUDIOLEVEL |
|
GAIN switch
1 Switch the gain with the GAIN switch. L:
Set here under normal conditions. (The default value is ISO400/0 dB)
M:
Increase the gain of the image amplifier. (The default value is ISO800/6 dB.)
H:
Increase the gain of the image amplifier. (The default value is ISO1600/12 dB.)
•You can change the L, M, and H gain values using the LOW GAIN, MID GAIN and HIGH GAIN on the setting menu SW MODE screen. (Page 54 of Vol.2)
Light intensity adjustments
Use the ND dial to change the ND Filter used (filter to change light intensity).
1:ND filter is not used.
2:Cuts light intensity by up to about 1/4.
3:Cuts light intensity by up to about 1/16.
4:Cuts light intensity by up to about 1/64.
ND dial
|
| START/ |
|
| ||
|
| STOP 2 |
|
| ||
|
|
| – | + |
| |
FOCUS | FUNCTION USER 1 | DISP/ | POWER.. |
|
| |
MODECHK | MODE |
| ||||
IRIS GAIN | WHITEBAL USER 2 |
| AUDIOLEVEL |
|
| |
|
|
| Shooting | |||
Adjusting the white balance | ||||||
|
In order to reproduce the white accurately, adjust the ratio between the three RGB primary colors. If the white balance is not adjusted properly, not only will the white be reproduced poorly but the color tones of the entire screen will also be downgraded. When you are shooting in manual mode, readjust the white balance whenever lighting conditions change.
You can save adjustments and reselect them by setting the WHITE BAL switch to A or B.
You can also use the preset values.
Use the settings to suit the shooting conditions.
WHITE BAL switch
AWB button
41