Setup
Setting date and time
When the unit is turned on for the first time, a message asking you to set the date and time will appear.
≥Press the button up or down button of the cursor button to select [YES], press the center of the cursor button and then perform steps 2 and 3 below to set the date and time.
If the screen shows the incorrect date and time, then adjust it.
¬Rotate the mode dial to select 
.
2Select the item to be adjusted by pushing the right or left button of the cursor button, and then press the center of the cursor button to make the selection. Make any further adjustments by pushing the up or down button.
DEC 15 2008 03 30 PM
≥The year will change as follows: 2000, 2001, ..., 2039, 2000, ...
≥The
≥The clock function starts at [00] seconds when the cursor button is pressed.
≥After pressing the MENU button to finish the setting, check the date and time display.
Changing the date and time display style
Press the MENU button, then select [SETUP] # [DATE/TIME] # desired display style and press the center of the cursor button.
≥You can also show or change the date and time display by repeatedly pressing the DATE/TIME button on the remote control.
[DATE][D/T]
DEC.15. 2008 | DEC.15. 2008 3:30PM |
[OFF]
Changing the display style
Press the MENU button, then select [SETUP] # [DATE FORMAT] # desired display style and press the center of the cursor button.
Display style | Screen display |
[Y/M/D] | 2008.12.15 |
|
|
[M/D/Y] | DEC 15 2008 |
|
|
[D/M/Y] | 15.12.2008 |
|
|
|
|
≥The date and time function are driven by a
≥Make sure to check the time before recording.
≥If the time display becomes [-
To recharge the
If you connect the AC adaptor or insert the battery in this unit, the
41