Basic operation (Continued)
ENGLISH
<Notes>
zIf a scene file is loaded while the volume operation mode is set to the absolute value mode, and then the VR ACTIVE button is operated, the set value will correspond to the volume angle and the loaded value will be lost.
If you want to operate the volume from the value loaded in the scene file, operate the unit while the VR ACTIVE button lamp is flashing or the operation modes of the volumes for WHITE and BLACK are set to the relative value mode before operating the VR ACTIVE button.
zWhen a scene file is stored or loaded, the button lamps for the file numbers of the files stored or loaded and the LOAD button is turned on. Press the LOAD button to turn the button lamp off. When the camera menu is opened or the scene file data is loaded from the SD memory card, the lamps for both of the File No. button and the LOAD button turn off.
zWhen the camera menu is open, operations of the scene file are disabled.
2)Items stored in the scene file
Refer to the Menu item Files for storing are checked with a “Yes” Since the same operation applies to storing on the SD memory card, when a scene file stored in a specific unit of the remote controller is used for another unit of the remote controller, load data from the scene file from the specific unit and store on an SD memory card, and then read them out from the card and store them in the scene file of the other unit.
<Note>
Do not turn off the power when a scene file is being stored. Otherwise, data in the scene file may be corupted.
<Reference>
It is possible to adjust the scene file setting of the unit to the same state as the factory setting for the camera recorder using the following procedure.
However, the settings that cannot be set with the unit cannot be set to the same state.
1 Set the settings for the camera recorder to the factory settings. For details, refer to the operation manual of the camera recorder.
2 Connect the unit to the camera recorder. Settings for the unit will be imported from the camera recorder.
3 Execute
4 Store the settings on the unit to scene files 1 to 5 of the unit or an SD memory card.
Operation for recording
If the RECORDER ENABLE button is pressed to switch to the recorder mode, operations of the camera recorder are enabled.
If the REC INH button lamp is on, the REC S/S button on the unit will be inhibited. To start and stop recording, turn off the lamp of the REC INH button by pressing the button, and start and stop recording using the REC S/S button.
<Notes>
zWhile the REC INH button lamp is on, REC S/ S button operations are inhibited.
zIf the RECORDER ENABLE button lamp turns off by pressing the button while the recording part is operated, the state of the recording before turning off the lamp is retained and it is possible to operate the scene file built into the unit.
zIt is possible to set whether the value adjusted on the unit is retained on the camera recorder or not, by using