Panasonic ASCT1F46E manual Check sheet 2/2

			Check sheet (2/2)
	Check			Refer to the following
Category			Check item	page and item on
	box			Page / Category -
				Section
Contact	□	Have precautions been checked in the case of switching with both high		ｐ9/7-1
		and low loads by the same contact?
reliability	□ Doesn't heat dissipation occur under low temperature?			ｐ9/7-2
Contact	□ Has transient state of contact resistance been considered?			ｐ9/8-1
resistance	□ Are contact voltage and current 6V 1A or higher?			ｐ9/8-2
Operating sound	□ Are there any problems regarding operating sound of relay?			ｐ9/9-1、ｐ9/9-2
Mechanical	□ Are there any problems regarding abnormal weak noise of relay?			ｐ9/10-1、ｐ9/10-2
noise

□Is temperature, humidity, atomosphere pressure within the range of use? ｐ10/12-1

	□	Have precautions been checked in the case of switching under high	ｐ10/12-1
		humidity?
	□	Is the ambient environment free from particles, dusts, sulfidizing gas,	ｐ10/12-2
		organic gas?
Use	□ Is the ambient environment free from silicon?		ｐ10/12-3
environmental	□	Is the ambient environment free from high-field magnetic instruments	ｐ10/12-4
condition
		such as speaker?
	□	Are the ambient vibration and shock below the relay's vibration and	ｐ10/12-5、ｐ10/12-6
		impact characteristics? Also, is there no resonance after the relay is
	□ Isn't there a risk of freezing and dewing of relay?		ｐ9/7-2、ｐ10/12-7、ｐ
			11/12-9
	□ Isn't there a risk of water or oil adhesion?		ｐ11/12-8
Mounting	□	Doesn't vibration or shock cause poor connection between a relay and a	ｐ11/13-1
		connector?
	□	Have precautions been checked for operating of flux applying and	ｐ13/15-1、ｐ15/15-2
		automatic soldering?
	□ Have precautions been checked for cleaning operation of print board?		ｐ13/15-1、ｐ15/15-2
PCB mounting	□	Isn't glass shot performed for flux cleaning? (Particle of the glass may	ｐ13/15-1、ｐ15/15-2
		get inside the relay and cause operation failure.)
	□	Does significant warping of print board occur, which applies a force on a	ｐ13/15-1、ｐ15/15-2
		relay teminal and changes the relay characteristics?
	□	Isn't the unused terminal cut? (Applied force on terminal can change the	ｐ13/15-1、ｐ15/15-2
		characteristics.)
Soldering	□ Any strong forces such as terminal clinch are not applied at attaching.		ｐ18/16-3
	□	Aren't load, shock, or vibration which is out of the allowable range	ｐ18/17-1
Storage,		applied during transportation?
	□ Are temperature and humidity within the allowable range?		ｐ18/17-2
transportation	□ Is the ambient atomosphere free from organic gas and sulfidizing gas?		ｐ18/17-2
Product	□ Aren't dropped or fallen tube packages used?		ｐ18/18-1
handling