Panasonic BB-HCM371 manual Multi-Camera Setup Supported IPv6-Ready IPsec*4 Supported

BB-HCM371	Network Camera
Multi-Camera Setup Supported	IPv6-Ready	IPsec*4 Supported

Simultaneous monitoring of images using up to four network cameras. Images from up to four camera units can be assigned as a group, and the monitor display can be switched to any of three image groups. This enables simultaneous display of the images from up to 12 camera units, with no audio.

Alarm-Controlled and Timer-Controlled Image Transfer Functions

The Alarm-Controlled Image Transfer function uses a commercially available external Sensor or switch and sends the image only when there is an action such as turning on the light or opening the door. The Timer- Controlled Image Transfer function automatically transmits images according to the set time zone and the day of the week. These convenient functions eliminate your need to constantly check the image.

*When e-mail function is used to transfer images or messages, e-mail transmission may not be possible in some cases due to the mail server authentication system (SMTP authentication, etc.) used by your Internet service provider.

*The image transfer functions can be used only with a PC. With a cell phone, only the e-mail transmission function can be used.

Supporting Viewnetcam.com service

Viewnetcam.com service allows you to access the camera over the Internet with your favorite domain name (e.g. bob.viewnetcam.com) instead of a global IP address. For more information on Viewnetcam.com service, Please access

www.viewnetcam.com for more information.

External Output Control

This provides ON/OFF operation of an externally connected device. For example, it can be used to turn on a light when the surrounding area becomes dark or to turn on a buzzer in case of an emergency.

Pan and Tilt Movement
		Pan
		(173° maximum)
		Tilt
		(105° maximum)
Lens cover	Antenna			Stand mounting section
Lens	RESET				External
	button
					microphone
	SD Memory				input terminal
	Card slot				Audio output
	Factory
	Default				terminal
	Button
	AC adaptor			Ethernet connector
Microphone	connector			(10/100Base-T(X))
Indicator	I/O connector		Stand/tripod mounting section
	*The photo shows the camera unit without the cover.

Our new network cameras allow the use of a virtually	IPsec is a technology used to encrypt data packets in
unlimited number of IP addresses*3 by supporting	order to prevent eavesdropping by third parties. When
IPv6, a next-generation protocol. The IPv4/IPv6 dual-	combined with a conventional authentication function
stack feature enables you to use IPv4 at the present	based on user names and passwords, IPsec offers
and switch over to IPv6 in the future.	enhanced security.

*1 This logo mark is issued by the IPv6 Ready Logo Program Committee, an IPv6 promotion group established mainly by the IPv6 Forum.

*2 This function can be used with a PC only. It cannot be used with a cell phone. To hear the voice transmitted from the PC, a commercially available speaker with a built-in amp must be installed. The transceiver system does not allow simultaneous transmission and reception of voices.

The BB-HCM371 may require a version upgrade to operate in the IPv6 environment.

For the latest information, visit Panasonic's support Web site (http://panasonic.co.jp/pcc/products/en/netwkcam/). *3 An IP address is a unique number assigned to each user so that the user can be identified on the Internet.

*4 IPsec is an IP security protocol for data encryption standardized by IETF, an international community devoted to the standardization of Internet specifications.

Specifications of BB-HCM371 Network Camera

	Model No.	BB-HCM371
	Product type	Outdoor, Wireless type and voice function
	Image data compression system	JPEG (Motion JPEG for moving image display)
	Resolution	640 x 480, 320 x 240, 160 x 120
	Image quality	3 modes (Favor Clarity, Standard, Favor Motion)
	Frame rate*1	Max. 30 frames/sec (320 x 240, 160 x 120), Max. 12 frames/sec (640 x 480)*2
	Security	User ID, password, IPsec
Server	Encryption algorithm	DES-CBC, 3DES-CBC, AES-CBC
	IPsec function*3	ESP encryption, EPS authentication, transport mode (main mode only)/tunnel mode
		IKE (Internet Key Exchange)
	Supported protocol	IPv4/IPv6 dual stack
		IPv4: TCP, UDP, IP, HTTP, FTP, SMTP, DHCP, DNS, ARP, ICMP, POP3, NTP, IPsec, UPnP
		IPv6: TCP, UDP, IP, HTTP, FTP, SMTP, DNS, ICMPv6, POP3, NDP, NTP, IPsec
	User access limit	Max. 30 simultaneous accesses (max. 10 accesses with voice reception)
	Buffered images*4	Approx. 125 images: (320 x 240), standard image quality
		(approx. 16 KB per image) (without using SD Memory Card)
	Viewing Angle	53° horizontal (total 173°)
Camera		40° vertical (total 105°)
	Pan	–60°up to +60°
	Tilt	–45°up to +20°
Network	Revolving speed	Pan: Max. 80°/sec, Tilt: Max. 80°/sec
	Number of pixels	1/4 inch, approx. 320,000 pixels, CCD sensor
	Lens focal point	Fixed (focal range: 0.5 m to ∞)
	Lens brightness	F3.5
	Required light intensity	3 to 100,000 lx (in Color Night View mode: 0.2 to 100,000 lx)
	Voice direction	Half-duplex two-way communication (transceiver system)
	Voice data compression system	ADPCM 32 kbps
Audio	Voice band	300 Hz ~ 3.4 kHz
	Audio input	Built-in microphone or external microphone (sold separately), external microphone input
		terminal (3.5-mm dia. mini-jack)
	Audio output*5	Audio line output terminal for external speaker
		(3.5-mm dia. stereo mini-jack, monaural output)
	Standards	802.11 b/g
Wireless	Antenna	Diversity
	Number of Channel	11 ch.
	Transmission Speed	up to 54 Mbps.
	Max. Transmission Distance	Indoor: About 120 m, Outdoor: About 600 m
	Security	WEP 64/128/152 bit
	Network Interface	Ethernet (10Base-T/100Base-TX)
	I/O connector for sensor	G GND
Terminal		1 External Senser Input
		G GND
		2 External Senser Input
		3 External Device Control Output
		4 DC Power Output Terminal (10.5–13.5V DC)
	SD Memory Card slot	Full size (operation guaranteed for 1GB, 512MB, 256MB, 128MB and 64MB SD Memory Cards)
	Operating temperature	–20°C to 50°C
General	Operating humidity	20% to 90% (No condensation)
	Dimensions (W x H x D)	Approx. 100 x 100 x 80 mm (Only the unit)
	Weight	350 g (Only the unit)
	Power Supply	AC adaptor: Input 120V AC, Output 12V DC
	Consumption	10W

*1 This varies depending on the subject, image quality, network environment, PC performance, etc.

*2 The image update speed may decrease when favor-motion mode is set, when images are recorded onto an SD Memory Card, and when IPsec is used, as well as due to the network environment and PC performance.

*3 Transport mode (mode for IPsec communication between terminals, for IPv4 only) operating environment: Microsoft® Windows® XP Service Pack 1 or later only, tunnel mode (mode for IPsec between VPN routers, IPv4/IPv6)

*4 The number of images that can be stored varies depending on the subject. *5 Install an amp or use a speaker with a built-in amp.

Specifications for Compatible PC

	For IPv4	For IPv6
OS	Microsoft® Windows®XP, Windows®2000,	Microsoft® Windows®XP, Service Pack 1
	Windows®Me, Windows®98SE	or later
CPU	• For monitoring of image from one camera unit: Pentium RIII (800 MHz or greater)
	• For monitoring of images from multiple camera units: Pentium R4 (1.8 GHz or greater)
Protocol	TCP/IP (HTTP, TCP, UDP, IP, DNS, ARP,	TCP/IP (HTTP, TCP, UDP, IP, DNS, ICMPv6,
	ICMP) protocol must be installed.	NDP) protocol must be installed.
Interface	10/100-Mbps LAN card must be installed.
Web browser	Internet Explorer 6.0 or later
Audio	Audio input/output function (microphone, speaker, etc.)

http://panasonic.co.jp/pcc/products/en/netwkcam/

Design and specifications are subject to change without notice. 10M0205SK-HCM371-LT.X Printed in Japan