Panasonic BB-HGW700A 2.6 Connect a Network Camera

23[For assistance, please call: 1-800-272-7033]

Installation/Troubleshooting

2.6 Connect a Network Camera

1. Connect the Ethernet cable between the camera and the LAN jack of the router.

2. Insert the AC adaptor cord into the DC IN jack of the camera.

3. Insert the AC cord into the AC adaptor socket and the plug into an outlet (The camera will be

turned on automatically.)

Camera Automatic Setup

If a Panasonic Network Camera (Customer-provided) is connected and the power turned on, this

product automatically sets the IP address, subnet mask and other network settings. After this

product is connected to the Internet, check that the camera is turned off and follow the steps

above.

1.

2.

3.

To the modem

To the PC

To the outlet

Contents

Main Network Camera Management System Installation/Troubleshooting BB-HGW700A Introduction How to Use This Documentation Abbreviations Trademarks 1Before Using 1.1 Important Safety Instructions 1.1.1 FCC and Other Information Page 1.1.2 Security Cautions 1.1.3 Open Source Software 2 Installation 2.1 From Start to Finish 2.2 Check the Accessories Main Unit and Included Accessories Accessories to be Provided by Customer 2.3 Connect This Product 1.2.3.4. 5. 1. 2. 2.4 Set Up the PC Page Page Page 2.5 Register an ISP and Connect to the Internet 1. 2. 3. 4. Setup Camera Portal * 5. Page Page Page Page Page Page 2.6 Connect a Network Camera 1. 1. 2. 3. 2. 3. To the modem To the PC To the outlet 4. 1) Enter "http://bbhgw.webpage:8080" 2) Click here. . 3) Click here. 5. 3 Troubleshooting Checking Connection Internet Website Display Setup Pages Display Page Camera Setup Wireless Setup Others Page When you ship the product Panasonic Consumer Electronics Company, Division of Panasonic Corporation of North America Panasonic Puerto Rico, Inc. For product service Copyright: