Panasonic BT-LT900A manual How to use the on-screen menus, Menu display, Status display

How to use the on-screen menus

Four kinds of information—menus, status displays, image control settings and battery voltage—can be displayed on the screen.

Menu display

[MAIN MENU]
1MARKER	4
VIDEO CONFIG	4
SYSTEM CONFIG	4
OSD CONFIG	4
GPI	4
INPUT SELECT	4
CONTROL	4

MENUEXIT XWSEL ENTERENTER

This display appears when the MENU/EXIT button is pressed. If no further action is taken for the next 120 seconds, the display will be automatically cleared.

The position where the display appears on the screen can be changed using the marker setting.

For details on the menu, refer to “MAIN MENU” (page 15).

Status display

1SDI1 1080/60I

CRCC

2DC150V.60%

3

1Channel and signal format

The channel which has been selected—whether SDI 1, SDI 2, VIDEO, YPBPR or RGB—is displayed here. Indicated as the signal format is the format of the signals which have been input. However, “UNSUPPORTED SIGNAL” will appear if signals which are not supported have been input.

Similarly, “UNSUPPORTED SIGNAL” will also appear if signals not selected as the FORMAT item setting on the INPUT SELECT screen of the main menu are input even when those signals are supported.

For details on the signals supported and format displays, refer to page 12.

The status display information is displayed under the following conditions while the menu display is not on the screen.

≥When the input signals have been switched

≥When the input channel has been changed

≥When no signals are supplied

The display location and display time can be changed using the menu settings. When images are adjusted using the image controls while the status display information is on the screen, the display is cleared, and the settings adjusted by the controls are displayed instead.

2Warning display

This appears when an error has occurred or when a special mode is being used.

CRCC	This indicates a CRCC error, and it appears
	when the SDI signals contain an error.
FILM	This appears when the film mode (FILM) has
	been selected as the GAMMA SELECT item
	setting on the VIDEO CONFIG screen of the
	main menu.
	This appears when REMOTE has been
	selected as the CONTROL item setting on the
	CONTROL screen of the main unit. The
	monitor controls will no longer function at this
	time.

3Battery voltage display

This indicates the voltage level of the battery. If an Anton Bauer digital battery is being used, its remaining level is indicated as a number of “∫” blocks and as a percentage along with the voltage value.

11