9-10

9.2. Reassembly Instructions

9.2.1. Attention when CF-19 series is repaired

• Please execute writing BIOS ID when you exchange the Main Board.

• Parts (Sheet and rubber) etc. related various the Conductive Cloth and Heat Spreader cannot be recycled. Use new parts.

9.2.2. Setting up the LED PCB, LCD Mod-

ule, Digitizer and LCD Unit.

1. Set the LED Module to the LCD UNIT.

2. Set the LED Plate Holder to the LED Module.

3. Set the LCD UNIT to the LCD Front Cabinet/TS Panel.

4. Set the Digitizer to the LCD UNIT

5. Fix the LCD Back Plate using the 2 Screws.<E36-15>

6. Set the LED PCB to the LCD Back Plate, and connect the

4 Cables to the Connectors.

7. Paste 2 Sheets and tape.

n Assembly of LCD Back Damper (Applicable Model : Touch Screen Model)

Sheet
LCD Back Plate
Digitizer
<E36-15>
<E36-15>
Sheet
LED PCB
Tape
LCD Unit
LED Module
LED Plate Holder
㽲㸢㽳㸢㽴㸢㽵
ℴ
Insert this between
LCD PCB & LCD Frame.
Ⅎ
LED PCB ASSY
TS PCB ASSY
LED PCB ASSY
0~0.5mm
0~1mm
0~1mm
0~0.5mm0~0.5mm
ℵ
0~1mm
0~1mm
<Note>
*Paste Sheets firmly. 20~30N(2.0~3.0Kgf)
TS PCB ASSY
Screw the Board and
the Spacer together.
Screw the Board and
the Spacer together.
Match to the center from right
and left to attach (± 1 mm).
Remove the Release Paper
on the back side and attach it.
Fit to the bottom
edge of Plate.
Fit to the Frame edge.
Fit to the
Frame edge.
Fit to the corner.
Fit to the
corner.
Attach LCD Back Cushion
on LCD PWB Spacer.
<Order of fixing screws>
LED PCB Sheet
LCD Back Plate
LED PCB
LCD Side Cushion Lower LCD Side Cushion Lower
LCD Back Sheet LCD Back Sheet
LCD Back Cushion
LCD Side Cushion
TS PCB
ASSY
Screw
Screw
LCD PWB Spacer
LCD Back Cushion
Torque of tightening screw :0.16~0.20N.m(1.6~2.0kgf.cm)
ℳScrew
Screw
TS PCB
Sheet
After inserting the connector,
slide the hook to lock
Attach between the ribs
on the side of Frame.
LCD Back
Cushion
LCD Back
Cushion
LCD Back
Cushion
LCD Back
Cushion