Panasonic CF19KDRAXCM 9-12, n Assembly of LCD PCB (Application Model : Digitizer Model), n Assembly of Touch Screen (Applicable Model : Touch Screen Model)

9-12
n Assembly of LCD PCB (Application Model : Digitizer Model)
n Assembly of Touch Screen (Applicable Model : Touch Screen Model)
LCD DA ASSY
Detail of "A"
1~2
mm
A
PET TAPE
(Sub material:)
FPC
Tape
CAUTION S1:Insulation S2:Bitten S3:Sharp Edge
S4:Part No. Check S5:Other
S5
LED FPC Sheet
TS Insulation Sheet
LCD Cable Bush
LCD Cable TS
PET Tape
Shield Sheet
LCD Side Cusion
LCD Side Cusion
Connecter
PCB
Attach firmly to avoid
FPC coming off.
LCD Side Cusion E LCD Side Cusion E
Insert between the ribs.
Insert between the ribs.
Insert TS FPC and attach
the sheet as above.
Insert between the ribs.
Insert between the ribs.
Insert between the ribs.
Insert between the ribs.
Pasted on the
connectorafter
it is wound around
the cable twice.
*Avoid running over the waterproof
rib of the LCD Front.
Avoid any stress on the TAB part of the
LCD Module because the line may come off.
Ensure the edge of the
conductive fabric is not
frayed to avoid short
circuit with the Board.
After attaching to
the Cable, insert
into the Cabinet.
Pass the LCD
Cable as below. Attach the
Tape as below. Fold the Tape as
below to attach.
Insert into the
Connector.
Attach it on the Connector.
Insert into the Connector.
Corner
±1mm
Attach as
covering
the Board.
0䌾1mm
0䌾1mm
0䌾1mm0䌾1mm
4䯂5䰆Don't get into a LCD indication range.
Be free of overhang..
OK
OK
T/S
T/S
NG
NG
Attach the surface to the LCD Front.
Apply the load 20 to 30N (2.0 to 3.0 Kgf) to the Cushions.
<Note>
Touch Screen Ass'y
Touch Screen Ass'y
Laminate
Laminate
Do not remove the
Release Paper of
the edge part.
Match to the edge of
TS FPC to attach
(0 - 0.5 mm).
*Remove it parallel to T/S.
Dimensional
tolerance:
± 0.2
Attach to the center of the display surface.
(Use the special attaching machine.)
Touch Screen
TS FPC Sheet
Protect Sheet
TS Spacer A
TS Spacer B TS Spacer B
TS Spacer A