9-21

n Assembly of the left LED PCB and right LED PCB

9.2.9. Setting the Power SW PCB

1. Connect the Cable to the Connector. (CN9)

2. Fix the Power SW PCB using the Screw. <N1>

Screws <N1> : DFHE5025XA

n Assembly of the Power SW PCB

LED(L) PCB Ass'y LED(R) PCB Ass'y
0 3mm
Back side
LED Light Guide Sheet(L)
LED PCB Tape(L)
LED PCB(L)
LED(L) FPC
LED Light Guide Sheet(R)
LED PCB(R)
LED PWB Tape(R)
Match the edge and attach it.
Match the edge and attach it.
Match the edge and attach it.
Avoid running over the LED.
Match the edge and attach it.
Ensure it does not come over the end
of the Board by 0.5 mm or more.
Avoid coming over it.

<N1>

Connector(CN9)

Power SW

PCB

䫹
㶎
Insert the Cushion
between the ribs.
Fold the board back and fix with screw.
*Avoid coming over.
No Screw
Necessary
PAD PWB Ass'y
Avoid running over the
rib, Cable and Board
after attaching.
Round to make the brown side
outside and insert the notch.
Insert the FPC.
Process the center
part as illustrated.
Avoid any stress on the
bottom part of the stiffening
plate during this work.
(If stress is placed, load is
applied on the coating part
and connection failure may
occur.)
Note
CAUTION S1:Insulation S2:Bitten S3:Sharp Edge
S4:Part No. Check S5:Other
Torque of tightening screw :0.2r0.02N࡮m(ѳ2.0r0.2kgf࡮cm)
S2
0~1mm
0~1mm
Thermal Sheet
Power Spring Sheet
Gasket
Gasket
Spring
Power SW PCB
Screw ℵ
Screw Ⅎ
Screw ℶ
Screw ℳ
Screw ℴ
(Note) Arrow without specified measurement: 0 ~ 0.5 mm
Avoid catching
the Cable
between the
Board and
boss.
Insert into the Knob and
Pin on the Top Case.
Attach
Insert
Keep the space of 1 mm between
the Top Case and the rib.
Attach to the
indent part of
the USB.