CQ-CB8901U
Power on
Press [SRC] (PWR:Power).
Note:The opening screen appears. You can overwrite
opening screen (moving image) with new one. (apage
37)
Power off
Hold down [SRC] (PWR)until you hear a
beep, then release it.
Note:The ending screen appears. You can change the
ending screen (moving image). (apage 37)
14
General
This chapter explains how to turn on or off the power, how to adjust the volume, etc.
CQ-CB8901U 15
You can remove the face
plate to prevent it from
being stolen.
Removing
1Press [] (Release).
(The face plate disen-
gages with a click
when it is removed.)
The face plate auto-
matically closes after
a lapse of 5 seconds
while it is open.
The power is automatically turned off while the unit
is active.
2Put the face
plate in the case.
Mounting
1Slide the left side of the face plate in
place.
2Press the right end of the face plate
until “click” is heard.
Cautions:
¡It is recommended to remove or mount the face
plate when the plate is at the closed position.
Do not remove or mount the face plate when the
plate is in motion.
¡This face plate is not waterproof. Do not expose it to
water or excessive moisture.
¡Do not remove the face plate while driving your car.
¡Do not place the face plate on the dashboard or
nearby areas where the temperature rises to high
levels.
¡Do not touch the contacts on the face plate or on the
main unit, since this may result in poor electrical
contacts.
¡If dirt or other foreign substances get on the con-
tacts, wipe them off with clean and dry cloth.
¡To avoid damaging the face plate, do not push it
down or place objects on it while it is open.
Open/Eject
Press [] (OPEN).
When a disc is already loaded, the disc will automatically
be ejected.
Close
Press [] (OPEN).
Tilt
The display angle changes among 4 levels as follows
every time you hold down [] (TILT)for 1 sec. or
more and release.
Note:The last selected
angle is memorized even
after turning off the power.
Notes:
¡The volume level can be set independently for each
source. (For radio, one volume setting for AM, one
volume setting for all FMs)
¡The volume is not adjustable (except XM mode) while
an error display is on the monitor. (apage 42)
qUp
wDown
Setting Range: 0 to 40
Default: 18
Volume off (down)
Press [] (MUTE).
Cancel
Press [] (MUTE) again.
Note: Volume-down range can be specified. (apage
35)
SRC
CQ-CB8901U
SRC
CQ-CB8901U
SRC
CQ-CB8901U
SRC
CQ-CB8901U
General

Power On/off

(PWR: Power)

Face Plate Motion (Open/Close, Tilt)

(OPEN/CLOSE, TILT)

Volume Adjustment

(VOLUME)

Temporary Volume Off (Down)

MUTE (ATT: Attenuation)
Cautions:
¡To avoid damaging the face plate, do not push it
down or place objects on it while it is open.
¡Do not pinch your finger or hand in the face plate.
¡Do not insert foreign objects into the disc slots.
¡For the following cases, the face plate automatical-
ly closes. Use caution not to catch your finger.
¡After a lapse of 20 seconds
¡When a disc is inserted
¡When the face plate is removed (apage 14)
TILT 1
TILT 2
TILT 3
OPEN
TILT OFF

Face Plate Removing/Mounting

(Anti-Theft System)