E N G L I S H

Installation

Warning

47This installation information is designed for professional installers with knowledge of automobile electrical safety sys- tems and is not intended for non-technical, do-it-yourself individuals. It does not contain instructions on the electrical installation and avoidance of potential harm to air bag, anti-theft and ABS braking or other systems necessary to install this product. Any attempt to install this product in a motor vehicle by anyone other than a professional installer could cause damage to the electrical safety system and could result in serious personal injury or death.

If your car is equipped with air bag and/or anti-theft systems, specific procedures may be required for connection and disconnection of the battery to install this product. Before attempting installation of this electronic component against the manufacturer’s recommendation, you must contact your car dealer or manufacturer to determine the required proce- dure and strictly follow their instructions.

FAILURE TO FOLLOW THE PROCEDURE MAY RESULT IN THE UNINTENDED DEPLOYMENT OF AIR BAGS OR ACTIVA- TION OF THE ANTI-THEFT SYSTEM RESULTING IN DAMAGE TO THE VEHICLE AND PERSONAL INJURY OR DEATH.

How to install the unit

Caution

¡Wear gloves for safety

¡Make sure that wiring is completed before installation.

¡When this unit is installed in dashboard,

ensure that there is sufficient air flow around the unit to prevent damage from overheating, do not block any ventilation holes on the unit.

Remove Mounting Collar q and Trim Plate r from the main unit temporarily, which are already mounted at ship- ment.

2

3

1 Remove the cable from the battery negative terminal.

2 Mounting collar q insertion.

Bend appropriate tabs to secure the unit without backlash.

3 Connection of power connector t.

4 Main unit securing

q Screw the Mounting bolt w into the main unit. w Secure to the fire wall.

e Snap the right and left springs into each hole.

5 Trim plate r mounting

6 Battery Cable reconnection

4 w

Securing to fire wall

 

Using the rubber bushing

Using the rear support strap

(Option)

 

 

(Option)

 

 

3 mm ø

Tapping screw (Option)

 

Rubber Bushing

 

 

(Option)

 

 

 

Mounting Bolt w

Rear support

 

 

 

strap (Option)

 

 

 

Mounting Bolt w

Rear support To the unit

 

bracket

 

Hexagonal nut

(supplied with car)

(Option)

 

 

4 q

4 e

Clank!

5

6

Snapping Point

48

CQ-D1703N

Page 48
Image 48
Panasonic CQ-D1703N manual Installation, How to install the unit