E N G L I
Troubleshooting (Continued)
E N G L I
S
H
19
❐CD
Trouble
Disc is in the CD compart- ment but no sound is made, or disc is ejected automatically.
Sound skips, bad sound quality (e.g. caused by noise)
Sound skips due to vibra- tion.
Disc is not ejected.
Time is counted but no sound comes out.
❐Sound Setting
No sound from left, right, front or rear speakers.
Left and right sounds are reversed in stereo listen- ing.
Cause/Step
Disc is upside down.
➡Place disc in the correct direction, and the label side up.
≥Disc is dirty.
≥Disc has scratches.
➡Clean disc, referring to the section on “Notes on CD/CD media
A disc that has data other than
➡Discs that have
➡The unit may not successfully play back a
≥Disc is dirty.
≥Disc has scratches.
➡Clean disc, referring to the section on “Notes on CD/CD media
➡The unit may not successfully play back a
Mounting angle is over 30o.
➡Adjust mounting angle to less than 30o.
Instable mounting.
➡Mount the unit securely with the mounting parts, referring to the section on installation.
≥Disc is defective.
≥Mechanical trouble.
➡Press [OPEN] to open the panel and press [<] (EJECT). If normal operation is not restored yet, call the store where you purchased the unit or the near- est Servicenter to ask for repairs.
The first track of a mix mode disc was reproduced. (Mix mode is a format in which data except music is recorded on the first track and music data is recorded on other than the first track in a session.)
➡Play back music data recorded on other than the first track.
Left and right balance, or front and rear balance is off on one side.
➡Adjust balance/fader mode as appropriate.
Cables are not correctly connected.
➡Connect the cables correctly.
The right speaker wire is connected to the left speaker and the left speaker wire to the right speaker.
➡Connect the speaker wires to the correct ones.
❐Remote Control
Trouble | Cause/Step |
Battery poles (i) (j) are reversed.
➡Insert the battery correctly.
Wrong the battery.
➡Check the battery.
Buttons are | invalid for |
operation. | Battery has run down. |
➡Replace the battery.
Remote control is in the wrong direction.
➡Direct the remote control at sensor (REMOTE) on the panel.
Error Display Messages
❐CD
Display | Cause/Step |
≥Disc is dirty, or is upside down.
≥A disc that has data other than
➡Press [OPEN] to open the front panel, and then press [<] (EJECT) to eject the disc.
Disc has scars.
➡Press [OPEN] to open the front panel, and then press [<] (EJECT) to eject the disc.
No operation by some cause.
➡Turn off the car engine (ACC off) and remove the fuse from the battery lead (yellow) for 1 minute. Then reinstall the fuse.
❐CD Changer
≥Disc is dirty, or is upside down.
≥ A disc other than a music CD
DISC No.➡Select the next available compact disc.
Disc has scratches.
➡Select the next available compact disc.
DISC No.
No operation by some cause.
➡Press [RESET] on the CD changer (optional).
No disc in the changer (magazine).
➡Insert discs into the changer (magazine).
Notes:
≥There may be cases where the disc numbers affected by an error are displayed before “E1” or “E2”.
≥Displays and the steps to be taken for errors vary in part from changer to changer. For details, refer to the operating instructions for the changer used.
S
H
20
28 | 29 |