- 13 -
Preparation
Battery
Installation
Clock Setting
Pull the insulation fi lm out from
the backside of the remote control
gently.
1Set your car’s ignition switch
to the ACC or ON position.
CCA
NO
The 24-hour system is used for the clock.
1Press[DISP].
(clock display)
2Hold down [DISP] for more than
2 seconds.
Hour blinks
3Adjust the hour.
Hour entered
[]: sets the hour ahead.
[]: sets the hour back.
4Press[DISP].
Minute blinks
5Adjust the minute.
Minute entered
[]: sets the minute ahead.
[]: sets the minute back.
6Press[DISP].
Completed
Notes:
• “ADJUST” is displayed before adjusting the clock.
• Hold down [] or [] to change numbers rapidly.
• When “NO DISC” is displayed, the clock cannot be
adjusted.
Clock Display at Power Off
Press[DISP] to change the display.
Display off
Clock display (Default)
2Press[SRC] (PWR: Powe r).
Note: Battery Information:
Battery Type: Panasonic lithium battery (CR2025) (Included
in the remote control)
Battery Life: Approximately 6 months under normal use (at
room temperature)
\CQ-RX300W\ \CQ-RX105W\
First Time
Power On
\CQ-RX300W\ \CQ-RX200W\
The demonstration message appears for initial
use.
1Set your car’s ignition switch to the ACC or
ON position.
2Press[SRC] (PWR: Powe r).
3Hold down [VOL](PUSH SEL: Select)for
2 sec. or more to open the function menu.
4Press[VOL] (PUSH SEL: Select)to select
DEMO.
5Turn [VOL] counterclockwise.
For using the remote control, press [0]().
Notes:
• To return to the regular mode, press [DISP].
• Refer to the section on “Function Settings”.
• When “NO USB” (\CQ-RX300W\) or “NO DISC” is
displayed, the Demonstration cannot be cancelled.