English
5
Installation (continued)
Mounting and removing the Main Unit
❏ Mounting Procedures (A) (When using Mounting Collar w)
Note: | IMPORTANT |
¡The car model, installation conditions and combination of the units used may impose some restrictions on opening and closing the monitor as well as on the angle and position to which the monitor can be adjust- ed.
q
When this unit is installed in dashboard, ensure that there is sufficient air flow around the unit to prevent damage from overheating. Do not block any ventilation holes on the unit.
qInsert the Mounting Collar w into the dash- board, and bend the mounting tabs out with a screwdriver.
wEstablish the rear connection of the unit. After fixing Power Connector !0, fix the rear of the unit to the car body by either method
(a) or (b).
eInsert the unit into Mounting Collar w. Secure the clamp plate of Mounting Collar w to the hook.
w
|
|
| Snapping point |
| e |
|
|
| r | r Insert Trim Plate q. | |
| t | t After installation reconnect the negative | |
|
|
| battery terminal. |
Method for Fixing the Rear of the Unit |
| ||
(a) Using the Rear Support Strap u. | (b) Using the Rubber Cushion (option) | ||
Fire wall of car | Rubber Bushing | ||
| 3 mmø | (option) |
|
u Rear Support |
|
| Rear Support |
Strap |
|
| |
|
|
| Bracket |
|
| To the unit | (Provided on |
t Tapping Screw |
| the Car) | |
|
| ||
(5 mmø x 16 mm) |
| r Mounting Bolt | |
| y Hex. Nut |
| |
|
| (5 mmø) | |
| (5 mmø) |
| |
|
|
| |
To the unit | r Mounting Bolt |
|
|
| (5 mmø) |
|
|
6
