![](/images/new-backgrounds/1263998/263998111x1.webp)
Installation
| English |
|
|
|
| Preparation | |
|
|
| |
|
| ||
|
|
|
|
| 3 |
| Caution |
|
|
| |
|
|
| ¡Please follow the laws and regulations of your |
|
|
| province or country for installation of the unit. |
|
|
| ¡When bending the mounting tab of the mounting |
|
|
| collar with a screwdriver, be careful not to injure |
|
|
| your hands and fingers. |
|
|
| ¡We strongly recommend you to wear gloves for |
|
|
| installation work to protect yourself from injuries. |
|
|
| ¡Before installation, check the radio operation with |
|
|
| antenna and speakers. |
|
|
| ¡Disconnect the cable from the negative |
|
|
| minal (see caution below). |
|
|
| ¡The unit should be installed in a horizontal position |
|
|
| with the front end up at a convenient angle, but not |
|
|
| more than 30°. |
0 – 30°
Caution
¡Do not disconnect the battery terminals of a car with trip or navigational computer since all user settings stored in memory will be lost. Instead take extra care with installing the unit to prevent shorts.
Dashboard Installation
Installation Opening
The unit can be installed in any dashboard having an opening as shown below. The dashboard should be 4.5 mm – 6 mm thick in order to be able to support the unit.
111.6 mm
182 mm
Installation Precautions
This product should be installed by a professional installer, if possible.
In case of difficulty, please consult your nearest author- ized Panasonic Service Centre.
1.This system is to be used only in a 12 V DC battery system (car) with negative ground.
2.Follow the electrical connections carefully (a page 8- 16). Failure to do so may result in damage to the unit.
3.Connect the power lead after all other connections are made.
4.Be sure to connect the battery lead (yellow) to the pos- itive terminal (+) of the battery or fuse block (BAT) ter- minal.
5.Insulate all exposed wires to prevent short circuiting.
6.Secure all loose wires after installing the unit.
7.Please carefully read the operating and installation instructions of the respective equipment before con- necting it to this unit.
4