Installation
Remote control battery installation
Replacing batteries
Replace batteries by following the steps below:
Requires two AA batteries.
1. Open the battery cover.
2. Install the batteries as shown 3. Replace the cover. in the battery compartment.
(Polarity + or – must match the markings in the compartment).
Two AA size
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Observe the following precautions:
1.Always use new batteries when replacing the old set.
2.Do not attempt to charge,
3.Battery replacement is necessary when remote control acts sporadically or stops operating this unit.
Notes:
•Do not drop, apply shock to or step on the remote control.
•Do not spill water on the remote control.
•Do not place objects between the remote control and remote control receiver.
•Do not use remote controls for other equipment at the same time.
•If the TV does not operate even when operating the remote control from a close range, it is time to replace the batteries.
Refer to the label on back of the remote control for directions on replacing batteries.
Maintenance
To clean this unit, wipe with a soft, dry cloth.
If the surfaces are extremely dirty, use a soft cloth dipped in a soap and water solution or a weak detergent solution.
•Use eyeglass cleaner to remove stubborn dirt from the LCD.
•Never use alcohol, paint thinner or benzine to clean this unit.
•Before using a chemically treated cloth, read the instructions that came with the cloth carefully.
Mild detergent
CAUTION :
If water or similar substances get inside the monitor via the liquid crystal panel surface, a malfunction may result.
7
