Note: The illustrations in this manual are for explanation purposes only and may differ from the actual unit. It is subject to change without notice for future improvement.
PRODUCT OVERVIEW
■About
Indoor Unit
Air intake
Remote Control Preparation
1. Pull out
OPEN
ENGLISH
Air Purifying filter Front panel
Auto OFF/ON
button Air filter
Receiver
Airflow direction louver
Discharged air |
|
Outdoor Unit | Indicator |
Air inlet (rear) |
|
Air inlet (side)
Air outlet
Remote Control |
| Transmitter |
|
2. Insert batteries (AAA or R03)
3. Press CLOCK button
4. Set current time
5.Press again to confirm
•Timer operation will be based on current time set.
•The batteries can be used for approximately 1 year.
•The batteries must be recycled or disposed of properly.
Remote Control Signal
•Make sure it is not obstructed.
•Maximum distances : 32.8 ft (10 m).
•Certain fluorescent lights may interfere with signal transmission. Consult your dealer.
Auto OFF/ON Button
•To operate the unit if the remote control is misplaced or malfunctioning.
LCD display
Operation mode Powerful operation
Quiet operation
Timer setting
Clock setting
���� |
|
���� | ��� |
��� | ����� |
| ��� |
| ����� |
�����
����� �����
���� | ������ | ECONOMY |
|
| |
�������� |
| ��������� |
|
| |
����� | ���� | ��������� |
| ||
|
|
����� |
|
|
�� |
| ��� |
|
| |
� | � |
|
| � | |
|
|
��� | ������ |
| |
����� | ����� |
|
Off/On
Economy operation
Temperature setting Fan speed selection
Airflow direction adjustment
Memory reset
Action | Operation | |
mode | ||
| ||
Press once | Automatic | |
Operation | ||
| ||
Press until “beep” | Cooling | |
sound | Operation |
•To turn OFF, press the Auto OFF/ON button again.
•To switch the remote control signal receiving sound off or on.
1.Press until you hear a “beep” sound and release.
2.Press again until you hear a “beep- beep” sound and release.
3.Press to switch the sound off or on. (Long “beep” - OFF; short “beep”
- ON)
Troubleshooting
●Operation delayed for a few minutes after restart.
●Sound like water flowing during operation.
●Mist emerges from indoor unit.
●Noisy during operations.
●Remote control/display does not work.
●The unit cannot operate.
●Outdoor unit emits water/steam.
➤This is a normal self protection function.
➤Caused by refrigerant flow inside.
➤Condensation effect due to cooling process.
➤Installation work could be slanted or front panel isn’t closed properly.
➤Check whether batteries are correctly inserted or need replacement.
➤Check whether circuit breaker is tripped or timer is being used correctly.
➤Condensation or evaporation has occurred at piping surface.
3