CW-A121VR
8.3.2.Remove the Front Grille.
•Remove the front intake grille
Pull up the front intake grille about 90° and slide it slightly to the left to unhook the tabs.
Caution: Do not raise the front intake grille anyhigher than 90°to the unit or damage to the tabs mayoccur.
•Remove the air filter.
Tilt up and pull out the air filter by holder.
•Remove the front grille.
1.At bottom right side of the front grille, press inward on cabinet near the power cord, and pull the grille outward to the right until right tab releases.
2.At bottom left side, push inward on cabinet and pull the grille outward to the left to release the left tab. Do not pull the bottom edge toward you more than 7.62cm to prevent two top tabs from damage.
3.Slide the front grille upwards to free the two top tabs from slots at the top of the cabinet.
8.3.3.Condensed water drainage
In order to drain off the condensed water, it is recommended that you install a drain pan using the following procedure.
•Slide the chassis out from the cabinet.
•Install the drain pan.
Install the drain pan at the left corner of the cabinet using 2 screws.
•Connect a drain hose. Fit the drain hose to the drain pan.
NOTE: Drain hose or tubing can be purchased locally to satisfy your particular needs.
•Slide the chassis back into the cabinet. Reinstall the cabinet to the chassis by using screws.
12
