2
ACCESSORIES
SELECT THE BEST LOCATION
INSTALLATION
(6 pcs) XTN5D25A
(5 pcs) CWH4580211
(Single or Double Window | 3 |
|
|
hung window) | |||
|
|
| |
Front grille |
|
| 12 inches |
|
|
|
|
NOTE
Check that none of the accessories are missing.
(6 pcs) XTT4D10C
SIDE VIEW
More than 4 inches
AIR CONDITIONER
WINDOW REQUIREMENTS
•Hot sun rays hitting the outside surface of the cabinet will create considerable heat load.
If the outside of the cabinet is exposed to direct sunlight,
consider building an awning to |
| 22 | 1 | /8” |
(min) | to 42- | |||
shade the cabinet while |
|
|
| |
providing ample area for the |
|
|
| |
heated air to be exhausted |
|
|
| |
from the condenser (both |
|
|
|
|
sides) and the top. |
|
|
|
|
This unit is designed for |
|
|
|
|
installation in standard double hung windows. |
|
| ||
NOTE
The unit may also be installed “through the wall”. You should, however, observe standard carpentry practices and frame the opening without violating local ordinances.
CABINET INSTALLATION
1 Cut the “Sealing Ribbon” |
| |
to the proper length, and |
| |
attach it along the bottom | Window sash | |
edge of the bottom | ||
sealing ribbon | ||
window sash. |
|
2 To prevent condensation water from dripping inside, the cabinet should be installed level or very slightly tilted to the outside.
3Secure the cabinet using screws.
INSTALLATION PROCEDURES
1Remove the rear cabinet screws and save for later use.
2Slide the chassis out from the cabinet.
Type A screw
Type B screws
Window sill
Inside of | Outside of sash |
sash | Window sash |
Top angle | Sealing ribbon |
Expandable panel
Type A screws
Window sash foam seal
HOW TO ASSEMBLE THE EXPANDABLE PANELS
•Expand the expandable panel fully into the grooves of the window frame, secure the expandable panel, left, right and top mounting frames to the bottom of the window sash using 4 screws type A and 2 screws type B.
•Secure the cabinet using wood screws type A.
•Cut the window sash foam seal to the proper size and seal the opening between the top of the inside window sash and the outside window sash.
NOTE
Top angle
Top sealing ribbon (To be attached to the top angle)
Type B screws
NOTE
This procedure applies to left and right of assembling expandable panel.
Expandable panel
Side sealing ribbon (To be attached to the expandable panel)
Type C screws
If a gap exists between the unit and window sash, you may use “Sealer” supplied with the installation kit for a better seal.
CHASSIS INSTALLATION INTO THE CABINET
1Slide the chassis into the cabinet.
2Reinstall the cabinet screws.
Secure the cabinet to chassis by using screws (from rear cabinet).
•Attach the top angle to the cabinet using screw type B (3 pcs).
•Insert expandable panels to cabinet sides as shown.
•Secure the first fold of expansion panel to cabinet using screw type C (3 each).
