WINDOW REQUIREMENTS
CHASSIS INSTALLATION INTO THE CABINET
•Hot sun rays hitting the outside surface of the cabinet will create considerable heat load. If the outside of the cabinet is exposed to direct sunlight, consider building an awning to shade the cabinet while providing ample area for the heated air to be exhausted from the condenser
(both sides) and the top.
This unit is designed for installation in standard double hung windows.
22 | to |
| 1 |
1Slide the chassis into the cabinet.
2Reinstall the cabinet screws.
Secure the cabinet to chassis by using screws (from rear cabinet).
NOTE
The unit may also be installed “through the wall”. You should, however, observe standard carpentry practices and frame the opening without violating local ordinances.
INSTALLATION PROCEDURES
1 Remove the rear cabinet screws and save for later use.
2 Slide the chassis out from the cabinet.
HOW TO ASSEMBLE THE EXPANDABLE PANELS
Top angle |
| |
Top sealing |
| |
ribbon (To be |
| |
attached to the | Expandable panel | |
top angle) |
| |
Type B screws | Side sealing ribbon | |
(To be attached to | ||
| the expandable | |
| panel) | |
NOTE | Type C screws | |
This procedure applies to left and right | ||
| ||
of assembling expandable panel. |
|
•Attach the top angle to the cabinet using screw type B (3 pcs).
•Insert expandable panels to cabinet sides as shown.
•Secure the first fold of expansion panel to cabinet using screw type C (3 each).
CABINET INSTALLATION
Wireless
INSTALLATION OF THE FRONT GRILLE
Depending upon the location of the AC outlet, route the AC cord to either the left or right side while installing the front grille.
Wireless
This figure shows the AC cord routed to the left side.
1 | Place the front grille on the |
|
| |
| cabinet first. |
|
| |
2 | Secure the front grille to the |
|
| |
| main chassis using screw |
| Wireless | |
| provided. |
|
| |
| INSERT THE |
|
| |
Attach the | (part no. | Slot in the | and the | |
to the frame. | frame (part no. | |||
|
|
| the front grille. |
|
1Cut the “Sealing Ribbon” to the proper length, and attach it along the bottom edge of the bottom window sash.
2To prevent condensation water from dripping inside, the cabinet should be installed level or very slightly tilted to the outside.
3Secure the cabinet using screws.
Window sash sealing ribbon
Wireless
The and the frame can be obtained separately from your nearest servicenter.
INSERT THE AIR FILTER
Type A screw
Type B screws
Window sill Type A screws
Inside of | Outside of sash |
sash | Window sash |
| |
Top angle | Sealing ribbon |
| |
Expandable panel | |
Window sash |
|
foam seal |
|
Attach the air filter to the intake grille
Wireless
PLACE FRONT INTAKE GRILLE OVER THE FRONT GRILLE
•Expand the expandable panel fully into the grooves of the window frame, secure the expandable panel, left, right and top mounting frames to the bottom of the window sash using 4 screws type A and 2 screws type B.
•Secure the cabinet using wood screws type A.
•Cut the window sash foam seal to the proper size and seal the opening between the top of the inside window
sash and the outside window sash.
Note :If a gap exists between the unit and window sash, you may use “Sealer” supplied with the installation kit for a better seal.
Slide the front intake grille slightly to the right to reattach the tabs and then push it down to close tight.
Wireless
Lift up about 90°.