Installation
How to Install the Unit
INSIDE | OUTSIDE | FENCE | |
| AWNING | ||
FOAM |
| ||
|
| ||
1/4 Bubble | HEAT | ||
RADIATION | |||
COOLED | |||
|
| ||
AIR |
|
| |
| About 1/2" | |
|
| |
Level |
| Over 20" |
|
|
1.To avoid vibration and noise, make sure the unit is installed securely and firmly.
2.Install the unit where the sunlight does not shine directly on the unit.
If the unit receives direct sunlight, build an awning to shade the cabinet.
3.There should be no obstacle, like a fence, within 20” which might restrict heat radiation from the condenser.
4.To prevent reducing performance, install the unit so that louvers of the cabinet are not blocked.
5.Install the unit a little obliquely outward not to avoid leaking the condensed water into the room (about 1/2” or 1/4 bubble with level).
6.Install the unit with its bottom portion 30~60” above the floor level.
7.Stuff the foam between the top of the unit and the wall to prevent air and insects from getting into the room.
8.The power cord must be connected to an independent circuit. The green wire must be grounded.
9.Connect the drain tube to the base pan hole in the rear side if you need to drain (consult a dealer.) Plastic hose or equivalent may be connected to the drain tube.
Window Requirements
NOTE: All supporting parts should be secured to firm wood, masonry, or metal.
Features and
WINDOW REQUIREMENTS
1.This unit is designed for installation in standard double hung windows with actual opening widths from 26" to 41".
The top and bottom window sashes must open sufficiently to allow a clear vertical opening of 18" from the bottom of the upper sash to the window stool.
2.The stool offset (height between the stool and sill) must be less than 1 1/4".
26" to 41" |
18" min |
REPISA |
PARED INTERIOR
DESPLAZAMIENTO
ALFEZAR
EXTERIOR
Installation
9
