Panasonic CZ-RD515U Installing with in-wall junction box, Installing directly onto the wall

A. Installing with in-wall junction box

(1)	Install the junction box (locally purchased) into the wall.
	(Figs. 2-a and 3)
(2)	Pass the wire harness through the junction box and
	conduit. (Fig. 3)
(3)	Insert a flathead screwdriver into the 5 tab locations
	and disconnect the back plate of the remote controller by
	lifting up slightly. (Fig. 2-b)
	The tabs are thin; take care not to chip them.
(4)	Pass the wire harness connector through the cord open-
	ing on the back plate of the remote controller.
	Use nippers or a similar tool to cut out the slots for the

In-wall junction box (locally purchased)

9/32"-3 (83.5mm) 3/16"-4 (106mm) Tab

2-3/8"	Back
(60mm)
	plate

Fig. 2-a Fig. 2-b

from the indoor unit

	remote controller back plate screws. Insert the spacers
	and use the machine screws to install the remote con-
	troller back plate. (Fig. 3)
(5)	Insert the connector into the PCB of the remote controller
	unit, and wrap the wire harness around the hook. (Fig. 4)
(6)	Store the excess wire harness inside the junction box,
	then hook the remote controller unit onto the top of the
	back plate and install the remote controller unit.
(7)	To remove the remote controller unit after it has been
	installed, insert a flathead screwdriver into the slot on the
	bottom of the case and turn it. (Fig. 5)

B. Installing directly onto the wall

(1)	Insert a flathead screwdriver into the 5 tab locations and
	disconnect the back plate of the remote controller by lift-
	ing up slightly. (Fig. 2-b)
	The tabs are thin; take care not to chip them.
(2)	Use tapping screws to directly fasten the remote con-
	troller back plate onto the wall. (Fig. 6)
(3)	Insert the connector into the PCB of the remote controller

In-wall junction box

Opening

Wire harness

Back plate

Machine screws

Remote controller

Fig. 3

PCB

Wall

Spacers

	unit, and wrap the wire harness around the hook. (Fig. 4)
(4)	Use nippers or a similar tool to cut out the slot on the top
	of the remote controller unit. Pass the wire harness
	through the slot, then hook the remote controller unit
	onto the top of the back plate and install the remote con-
	troller unit.
(5)	In order to conceal the exposed wiring, use a wire cover
	(locally purchased) or similar means.

Hook	Slot
Connector
Fig. 4	Fig. 5

NOTE

‡When installing the remote controller back plate, be sure that it is flat and straight. Do not over-tighten the installa- tion screws.

‡Install the remote controller away from all sources of elec- trical noise.

‡Install a noise filter or take other appropriate action if elec- trical noise affects the power supply circuit of the unit.

Wire harness

Cut out

Wall

Back plate

Tapping screws

Remote controller

Fig. 6

2