–15–
Æ
ß ¨
™
®
≠
´
Shooting (Recording)/Playback Function Section (2)‹CC/ND FILTER (filter selector) knob
This selects the filter to match the light source which is illuminating the subject.
If the setting of this knob is changed when the menu display mode has been set to “3” (default
setting), the new setting will appear on the setting change message display area of the view-
finder screen.
(The viewfinder shown in the
illustration is the AJ-VF10P.)
Controls and Their Functions
ÈThe knob and filter settings are
listed below.
FILTER Description
knob setting
13200 K
25600 Ko1/8ND
35600 K
45600 Ko1/64ND
ÈExamples of filter settings to match
shooting conditions
Filter Shooting condition
1Sunrise, sunset, inside a studio
2Outdoors under a clear sky
3Outdoors under a cloudy or rainy sky
4Snow scenes, high mountains,
coastlines and other extremely clear
and bright scenes
›Synchro scan adjustment switches
These switches are used to adjust the synchro scan speed. Pressing the “p” switch reduces
the shutter speed; pressing the “o” switch increases the shutter speed. Set these switches to a
position where the side bar noise in the viewfinder is eliminated during personal computer
monitor shooting, etc.
|Note{
When these switches are used for UB/TC/CTL settings while the SET position has been select-
ed as the TCG switch position, they will not serve their function as synchro scan adjustment
switches. The TCG switch must be set to F-RUN or R-RUN for these switches to serve their
function.
fiWHITE BAL (white balance memory selector) switch
PRST: Set to this position when there is no time to adjust the white balance. The white bal-
ance value for 3200 K is stored in the memory.
A or B: When the AUTO W/B BAL switch – is pressed to the AWB side, the white balance
is automatically adjusted in accordance with the setting position of the filter knob ‹,
and the adjustment value is stored in memory A or memory B.
When the FILTER knob and the WHITE BAL switch are set to the same positions as the ones
set when the adjustment was made, the adjustment value stored in the memory is called, and
the unit is automatically adjusted to the white balance which corresponds to this value.
If the setting of this switch is changed when the menu display mode has been set to “3” (default
setting), the new setting will appear at the WHITE BAL switch display position on the viewfinder
screen. (Example: “A”)