Panasonic DMC-SZ1, DMC-FH8 118, Please turn camera off and then on again/System Error

Others

[Please turn camera off and then on again]/[System Error]

•This message appears when the camera is not operating properly.

>Turn the camera off and on. If the message persists, contact the dealer or your nearest Service Centre.

[Memory Card Error]/[Memory card parameter error]/[This memory card cannot be used]

>Use a card compatible with this unit. (P16)

–SD Memory Card (8 MB to 2 GB)

–SDHC Memory Card (4 GB to 32 GB)

–SDXC Memory Card (48 GB, 64 GB)

[Insert SD card again]/[Try another card]

•An error has occurred accessing the card.

>Insert the card again.

>Insert a different card.

[Read Error/Write Error Please check the card]

•It has failed to read or write data.

>Remove the card after turning the power [OFF]. Insert the card again, turn the power on, and try to read or write the data again.

•The card may be broken.

>Insert a different card.

[Motion recording was cancelled due to the limitation of the writing speed of the card]

•Use a card with SD Speed Class with “Class 4” or higher when recording motion pictures.

•In the event that it stops even after using a “Class 4” card or higher, the data writing speed has deteriorated so it is recommended to make a backup and then format (P44).

•Depending on the type of the card, motion picture recording may stop in the middle.

[Cannot record due to incompatible format(NTSC/PAL) data on this card.]

>Format the card after saving necessary data on a PC etc. (P44)

>Insert a different card.

[A folder cannot be created]

•A folder cannot be created because there are no remaining folder numbers that can be used.

>Format the card after saving necessary data on a PC etc. (P44)

[Picture is displayed for 16:9 TV]/[Picture is displayed for 4:3 TV]

•Select [TV Aspect] in the [Setup] menu if you want to change the TV aspect. (P43)

•This message also appears when the USB connection cable is connected to the camera only. In this case, connect the other end of the USB connection cable to a PC or a printer. (P102, 105)

[This battery cannot be used]

•Use a genuine Panasonic battery. If this message is displayed even when a genuine Panasonic battery is used, contact the dealer or your nearest Service Centre.

•If the battery terminal is dirty, clean it and remove any objects.

- 118 -