Panasonic DMC-TZ3 Cont.Af, Settings Burst setting Speed No. of pictures, High speed, Low speed

Settings:

	BURST setting				Speed 1		No. of pictures 2
	OFF					No burst
		(High speed) 3			3 pictures/sec		Fine: Max. 5
							Standard: Max. 7
		(Low speed) 3			2 pictures/sec
	3,		4 (Free)		Approx. 2 pictures/sec 5		Until card/built-in memory is full
1	: Depends on shutter speed and ‘SENSITIVITY’ settings.
2	: When using self-timer: Fixed at 3 pictures
3	: DMC-TZ3 only.			4 : DMC-TZ2 only.

5 : DMC-TZ3: Becomes progressively slower. (Delayed timing depends on card type, picture size, and QUALITY.)

DMC-TZ2: Depends on type of card, ‘PICT.SIZE’ (P.52), and ‘QUALITY’ (P.53).

Burst speed may be reduced if using SENSITIVITY (P.51) of ‘ISO400’ or greater, or if shutter speed is reduced in darker locations.

This feature cannot be used with the flash (flash mark turns red, P.36) or with ‘AUTO BRACKET’ (P.38, DMC-TZ3 only).

Settings will be stored even if power is turned off. Focus is fixed from first picture.

Exposure and white balance are set as follows: ●DMC-TZ3

High speed: Setting fixed from first picture.

Low speed, Free: Reset for each picture. ●DMC-TZ2

Reset for each picture.

When using BURST while following a moving subject in locations with major differences in brightness (e.g. indoor to outdoor), exposure stabilization may require a little time, and optimal exposure may not be achieved.

Auto review performed regardless of ‘AUTO REVIEW’ setting.

CONT.AF

Focus is continually adjusted according to movement of subject. (Increases battery consumption)

Applicable modes:

Settings:

OFF : Not set ON : Set ( displayed on screen)

Focus alignment may take time if zoom is suddenly changed from max. W to max. T, or if suddenly moving closer to subject.

Press shutter button halfway if focus is difficult to align.

When using , , or ‘AF mode’, focus will be aligned quickly when shutter button is pressed halfway.

Focus is not re-adjusted during motion picture recording.

VQT1B61 55